How to set up handler for microblaze interrupt? - Stack Overflow I'm trying to use microblaze interrupt to handle with simple gpio button interrupt In the block, only gpio and uart is used as well as interrupt controller Interrupt controller is set for level
Why does the data type `intc` in numpy default to 32 bits? np intc is defined as an integer with the size of int in C in the compiler used to build the runtime (see here) In most modern compilers, even in 64-bit toolchains, int is defined to be 32 bits (see here) In your case you are using a 32-bit compilation of Python, the chances of a compiler producing 32-bit binaries having int defined as anything else than 32 are quite low You can check the
Problem in AXI GPIO interrupt handling in ZYNQ The interrupt should be at 61 (29 + 32 = 61): interrupts = <0 29 4>; I enable the interrupt enable register and global interrupt register I want to write a kernel module and register the axi-gpio interrupt in that and register a ISR to handle it the main part of my code is as follows:
VS Code autocomplete for YAML JSON config settings in Python files In a Python script that imports this config somehow (either as a dictionary of dictionaries, or any other format), I would like an autocomplete on the keys: e g , if I type config para, I would like VS Code to propose autocompletes with param1, param2 or param3 And, ideally, I would like clicking on config param1 to bring me to the corresponding entry in the YAML file I want to avoid
numpy - Python range with np. intc - Stack Overflow Yesterday I asked here a question about a weird behavior of python range() I accidentally used range() instead of np arange() But depending on the input int-type it works for mathematical operati
Multibyte UART messages of different lengths using UartLite I have an Arty Board using XUartLite to communicate with my laptop I want to receive multibyte messages of differing lengths The second byte contains the message type and I can then determine ho
c - Software interrupt with microblaze - Stack Overflow I am using the INTC module and the fast interrupt method mentioned in there I have read this document, and thought of the software break, but I am confused as to why I cant get the software interrupt working as it is hinted everywhere in the INTC document that it should work