How to Adjust the Pressure in a Lawn Genie L7034 Anti-Siphon . . . - Weekand The Lawn Genie L7034 Anti-Siphon Valve is equipped with a flow-control screw so you can easily adjust the rate the sprinklers emit water The flow-control screw adjusts the amount of water pressure that goes to the sprinkler zone serviced by the valve
Frequently Asked Question - Lawn Genie If after the timer is unplugged the sprinklers still do not stop running, you may have a stuck valve If you’re not sure which valve controls the running sprinklers, feel the valves, and you should be able to tell which valve water is running through
Lawn genie L7010, L7034 User Manual - ManualMachine. com The L7034 (3 4") and L7010 (1") are anti-siphon valves with a flow adjustment screw, and can be operated electronically or manually In areas where freezing conditions occur, make provisions for draining the system
Lawn genie anti siphon valve manual The Lawn Genie L7034 Anti-Siphon Valve is equipped with a flow-control screw so you can easily adjust the rate the sprinklers emit water The flow-control screw adjusts the amount of water pressure that goes to the sprinkler zone serviced by the valve
Problem with Lawn Genie L1034 valves - Lawn Care Forum Directions say to have the flow control turned off, turn the bled screw counterclockwise to turn the water on, adjust the flow control and then tighten (clockwise) the bleed screw to turn the water off
The Lawn Genie Promise - Limited One Year Warranty Lawn Genie - Toro The L7034 (3 4") and L7010 (1") are anti-siphon valves with a flow adjustment screw, and can be operated electronically or manually In areas where freezing conditions occur, make provisions for draining the system Use a shut-off valve installed on the main line feeding the sprinkler system To
Product Literature - Lawn Genie Some of the Timer or Controller manuals below are used for multiple products If the manual for your controller shows a different model on the front page, do not be concerned Although the instructions are written for another controller, they will still apply to your model