Is orca slicer any good : r 3Dprinting - Reddit Orca is based on Bambu which is based on Prusa which is based on something else that is probably based on something else Orca and Cura have different user interfaces and preference is a personal thing They also have different slicing engines so they produce different tool paths
Does the cost estimator in orca not work? : r BambuLab - Reddit ANSWER: I was having the same issue I was a little stumped at first, but after looking at the settings between Orca and Bambu, I noticed there was a "Time Cost" setting in the PRINTER SETUP section in Orca but not Bambu When I set up the printer profile, I had put a value of $10 hr in there
First layer settings in Orca Slicer? : r OrcaSlicer - Reddit I'm new to Orca Slicer (have been using Cura mostly for years) I'm trying to switch over, but it's a learning curve Recently, I have been wanting to close some gaps on a first layer with an inset design, and so I went looking for the first layer settings in Orca Slicer 1 6 6 (but have not found them) I have the "advanced" switch on, and have checked under the tabs for quality, speed, other
OrcaSlicer - Reddit Unofficial space for Orca Slicer users to discuss settings, features and tips
Whats the advantage of orca slicer? : r BambuLab - Reddit Software is moving fast these days on the slicer front About a month ago, Bambu ported all the orca features to their main slicer and added some more calibrations of their own Then orca ported over their additions so the two slicers are pretty much on equal footing However orca has overtaken Bambu again in features in the last month
Getting started : r OrcaSlicer - Reddit Just bought my first 3d printer (creality k1) and was recommended using orca slicer so looked it up and haven't heard 1 complaint Found a sample I wanted to test it out with but once I downloaded it I couldn't find the file through orca to work with it Checked the type and it seemed right so I feel I'm missing something and it's probably simple
My OrcaSlicer profiles configs inspired from Ellis and Mak - Reddit I had decided to try out Orca Slicer but could not find much in the way of configs, when before I had used the AndrewEllis93's super slicer profiles, and MAK's Prusa profiles So I took ellis' profile and copied that over to Orca, as well as adding (still working on) the quality print configs from Mak's stuff
PSA: Use OrcaSlicer with your Ender-3 : r ender3 - Reddit Just using the stock Orca slicer settings for the Ender-3, then I just turn up the speed when printing Usually printing at about 150-200% Either crank up the speed with the nob on the Ender, or do it in the Orca slicer device tab, if you have your Ender set up with Octoprint, otherwise you will need to adjust print speed on the printer itself