International 856 | Tractor Forum International 856 for Sale I have an International 856 for Sale It is set up with a Cameco sugarcane loader ditch digger (a VERY large bolt-on attachment!) It is also configured as a high crop, with front wheel extensions and large rear wheels
Farmall 856 Rops. - Tractor Forum 856 rops I know that at one time there where retrofit kits for older tractors mandated by the government Iam hoping to find one of those No the Farmall 856 did not come from the factory with a ROPS as far as I can tell I've seen pics of them with ROPS and would like to find one to install on this tractor
International 856 diesel in oil - Tractor Forum I'm looking at buying a 1970 International 856 that is in need of some work The owner says that there is diesel getting in the oil and that the dealership told him it was due to bad injectors Is this a possibility? I don't know much about diesels but my first thought was that the engine
IH 856 Diesel sluggish on the go! - Tractor Forum Check with the repair shop on what type of clutch plate you have in your Inter, most likely will be the metallic finger clutch plate and most likely 6 fingers, these are good clutches but are not designed for prolong slipping when moving off, these type are either on or off, with prolonged slipping and even with the foot riding on the clutch will induce major wear to the clutch plate and the
TECHNICAL MANUAL - Tractor Forum and the same is true for the 855 and the 856 tractors The 655, 756 and 856 tractors were all discontinued before the late model 755 and 855 tractors and the new 955 tractors were produced Therefore, any late model references do not include the 655, 756, and 856 tractors MX,TM1360,IFC -19-16OCT91 Introduction TM1360 (16OCT91) 55, 56 Series
Differences, Pros Cons Between 1066 and 1086 - Tractor Forum The german diesels were the 310 in some of the 706's and the 756's and the 407 in the 856's We have a 706 gas and a 756 diesel at home When not abused the torques will last a long time The problem seems to be abuse of them constant shifting and slow shifting of them
Steering wheel removal - Tractor Forum Been try to remove with puller and it keeps breaking parts of steering wheel off where puller mounts underneath I attatched pics Any ideas, or will I have to cut it off Also been spraying it with blaster an letting it soak with puller on with tension Leave it overnight and try to remove and
No steering on my 1066 - Tractor Forum Have you tried bleeding the steering lines? Perhaps air got into the system I haven't studied the hydraulic circuits on my '66 series Internationals, but from what I remember the shop telling me, there is supposed to be a bypass valve in the MCV assembly on the side of the tractor that allows the steering to get full oil flow even if the tractor shuts down as a safety for on the roadway
WATER IN OIL - Tractor Forum Case 580D Diesel Backhoe Construction King Took off head Does not appear to have any cracks Going to take it in and magna Flux Repair if necessary Seal: No cuts or marks Clean That's as far as we got We will ck piston sleeves if we have to Any other thoughts suggestions