Dynamic Power Steering (DPS) problem | Page 2 | Can-Am ATV Forum P0562: MODULE: DPS DESCRIPTION: System Voltage low CAUSE: Blown fuse, battery low (damaged magneto regulator), damaged circuit wires or connection, intense winch usage ACTION: Check the two DPS fuses Validate that all the DPS connectors are secured Measure voltage between harness connector DPS2-A B and ground (expected value – 11 to 13 volts) Measure batter voltage with engine stopped
P0562 and P1F00 | Can-Am ATV Forum The next morning, i started the bike, ran it for a little while and the dps light came back on, i looked in the display for any code and found P0562 and P1F00
Dynamic Power Steering (DPS) problem | Can-Am ATV Forum Hi guys First off, English is not my first language, so please bear with me I have a 2021 Can-Am Outlander Max XT 650 T Yesterday when I powered up the power steering didn't work and the display reported there was a DPS problem I switched the engine and ignition off and then back on again
Service Manuals hosted locally for Can-Am Forums Due to Russian sources being blocked and other sources hard to find, I am hosting manuals and linking to them here I will be adding manuals as I get them I will be grateful for anyone who wants to add manuals to this thread I will add them to this first post If you download a manual, please
DPS vs XT - Can-Am ATV Forum I’m new to the Can-Am market, had two Honda ATV’s and thinking about getting into a Defender HD8 XT Can anyone explain what the differences are between the DPS and XT? Seems to be around a $2k price difference Is the XT worth it? Any insights regarding the HD8 would be really helpful too
Handlebars steering stuttering then Check DPS then failure Howdy gents, Went for a ride today and halfway through I started feeling the handlebars stuttering so I stopped and indeed the handlebars steering would stutter at a standstill as I barely tried to steer As if the DPS was twitching I turned the ATV off and removed the front inner fenders to
New 2024 can am defender hd7 Problems | Can-Am ATV Forum Hey guys Just picked up what i though was a great deal on a new hd7 dps Love it, but randomly it stalled on me when going from reverse to forward and sometimes idles rough And occasionally has a rough idle The dealership did say it sat for a year, and the gas did smell a little funky Think
DPS not responding help. Dynojet installed | Can-Am ATV Forum Here are a few potential causes and solutions: Blown Fuse: A common issue is a blown 40A fuse, which can cause the DPS to fail If the fuse blows immediately after replacement, there might be a short circuit somewhere in the wiring1 Electrical Connections: Check the electrical connections to the power steering unit
Fuse position - Can-Am ATV Forum The DPS fuse holder is located behind the rear of the right side panel (this is a 40A fuse) 2020 Defender HD10 6x6 2015 Outlander 1000 6x6 XT (Sold) 2012 Outlander 1000XT (Sold) 2004 Honda Rincon (Sold) BombardierBomb Tozguy 1lunger Save Share Like 1lunger Discussion starter 143 posts · Joined 2022 #3 ·Jan 8, 2023
DPS Steering Calibration - Can-Am ATV Forum Hey guys, I am looking for some advice help on my following problem with the DPS unit Lately my bike has been pulling hard to the right, and I was able to pin-point the problem to the DPS unit I took it to a local guy who owns a BUDS unit, and it was reading -22Nm The problem is, "For