MIPI-DSI panel support on iMX8M Mini - NXP Community Hi All, We have made a custom board using iMX8M mini SOC We need to integrate MIPI-DSI panel on this board we have few doubts on, Which panel driver to be used ? the Frame-buffer driver or DRM driver? Referring to the document i MX Linux reference Manual (4 14 98) In Section 6 2 2 Frame Buf
IMx93 uses lt9611 chip to convert MIPI into DSI without image display We use lt9611 to convert MIPI DSI to HDMI,then make the following configuration in the kernel： 1 Configured DRM_ LONTIUM_ LT9611=y in defconfig 2 Configure lt9611 and mipi dsi definitions in the device tree hdmi@39 { compatible = "lontium,lt9611"; pinctrl-0 = < pinctrl_9611>; pinctrl-names = "defau
Configure LVDS to MIPI DSI Display Bridge (LT9211C) on iMX8MP Hi NXP Team, I’m currently working on integrating the Lontium LT9211C display bridge with the i MX8MP EVK My use case is to input LVDS from the SoC and output MIPI DSI via the LT9211C The panel side (MIPI) has been validated using the bridge’s internal pattern generator, so the output pipeline fro
MIPI-DSI Frames check - NXP Community Hello everyone, I'm currently trying to enable the MIPI-DSI display based on the Imx8mp Variscite board Hoping that someone can help me I'm using the following setup : Driver : panel-rocktech-hx8394f c updated regarding the TFT (based on a HX8394F controller) DST : imx8mp-var-dart-dt8mcustomboar
How to enable MIPI-DSI on iMx8DualX QNX platform I have requirement to setting configure MIPI-DSI on QNX 1 Hardware diagram and some background, our product include two parts: 1) One part is the display which is an independent panel with deserializer(MAX96752F) + LCD Panel + mcu 2) Another part is the mainboard which include i MX8 + serializer(M
MX95 on DT8MCustomBoard MIPI-DSI out - NXP Community I've managed to get MIPI-DSI working so video is routed on MIDI-DSI bus, out from J11 connector on DT8MCustomBoard, over to ADV7535 bridge and in to external HDMI display
[IMX93] MIPI DSI VIDEO Mode and PLL Clock Setup for Multiple . . . I'm trying to port the mipi dsi interface and bridge the signal to HDMI output There are several resoultions are required, such as 1080P, 720P and 800x600 So I setup the lcdif VIDEO_PLL timing for supporting these resolution lcdif { status = "okay"; assigned-clock-rates = <1039500000>, <14844