Loading Filament - Flashforge Insert each filament into the IFS module in order (or randomly) When the screen displays "Filament auto-loading, please wait ", it will load the filament to the preset position of the 4-in-1 guide tube
AD5X Flashforge User Group | IFS problem again | Facebook IFS NOT WORKING Hi everyone, I’m having an issue with my Flashforge AD5X IFS (Intelligent Filament System) — the fourth filament slot doesn’t auto-feed when I insert filament The other three work perfectly Here’s what I’ve already tried: Triggered the auto-feed system manually from the printer menu (motor works fine) Unplugged the printer and disconnected the IFS to check for any
Flashforge AD5X User Guide - Manuals+ To clean residual filament inside the nozzle, you can perform multiple filament loading or manually clear any remaining filament using the unclogging pin tool After replacing the nozzle, please perform leveling again
EN CN - A02 AD5X User Guide To prevent filament from absorbing moisture, breaking, or causing issues with the guide tube, please unload the filament from the printer and store it in a sealed, moisture-proof container if the printer will be idle for more than two days
AD5X - Z-Mod - Firmware for AD5M AD5MPro AD5X The printer will cut the filament, then return to the prime tower to unload and load filament, then immediately continue from there On the first layer, the printer will instead travel to the trash chute while changing filament, but will return to the prime tower afterwards without producing any poop
Flashforge AD5X Top Mount IFS by Ragnarok84 - Thingiverse Place shim over the dowels, Run the IFS control cable up the back to the IFS and lock it down in the groove in the shim with the clampJoin tubes with as many Bowden collectors as you like and feed up through the plug