Hood hinge adjustment or replace? | For B Bodies Only Classic Mopar Forum I'm one of those guys that go with 4-pin race hoods, so I'm not versed in hood hinges, hence the plea for advice! 72 Charger, basic model, so no scoops, etc When I close the hood the rear of the hood - closest to the windshield - remains partially up (not flush to the fenders, etc ) Once the
Door Hinge Repair - For B Bodies Only Classic Mopar Forum The standard oversize is 375 and the max oversize id 409 The brass bushings never intended to support weight Ever wonder why the factory only used the oil-ite bushings on the top hinges ? Bet you had a hard time drilling the door side of the hinge, wait you don't have to with the bushing kit because it goes on the soft body side hinge half
Hood Hinges - For B Bodies Only Classic Mopar Forum The hinges may be the same, but springs can vary Just for a single year for example (1970) the hoods with air grabber mechanisms had stronger springs than the flat hoods
Door hinge rebuild - Resto Rick Rebuild Kit - For B Bodies Only Classic . . . I'm redoing a 70RR and needed to get my doors mounted so I can position the quarters and make sure it all fits correctly In doing so, I decided to rebuild the hinges and ordered a kit from Resto Rick I chose to do the uppers first as they were pretty rough and I felt they'd be the easiest to
Rebuilding door hinges - For B Bodies Only Classic Mopar Forum Finally planning to get back to a few maintenance and repair items on my car - one being to replace the bushings and pins in the door hinges Question is - any tricks of the trade or tools to use to remove the lower hinge springs and reinstall them? Thanks for any help that can be provided
Door alignment? - For B Bodies Only Classic Mopar Forum Rubber mallet and BFH - Help move stuck hinges or ???? Pieces of heater hose - Strategically placed between a section of door and body and used as a tool to deform the metal by forcefully closing the door on the piece of hose
Adjusting the hood hinges - For B Bodies Only Classic Mopar Forum Alot going on with hood hinges, meaning there is a lot of adjustment and on top of that is the fenders themselves which the hinges are bolted to Normally, yo would get the fenders aligned with the gaps set, then you would add the hinges and adjust the hood and lastly you would add the pins