LFE vs. LFE+Main - AVS Forum I have a Denon AVR-X3400H for mixed usage—music, movies and games I'm wondering what the best setting for my subwoofer might be with my two front tower speakers, particularly for music With a crossover at 60Hz, should I use LFE or LFE+Main?
LFE, subwoofers and interconnects explained - AVS Forum The LFE channel progressed from early analogue magnetic formats, to the digital channel in cinematic versions of Dolby Digital, and in turn to the home versions of Dolby Digital, DTS and MPEG Multichannel found on DVDs The rules remain the same: the encoded LFE signal needs a 10dB boost
What is your LFE low pass filter setting? - AVS Forum I'm curious what people set the LFE low pass filter (lpf) to in their receiver or pre pro I know technically 120hz should be the correct setting as that is the limit of the LFE channel but in the Audyssey thread and other threads it has been discussed that people recommend an 80hz setting as
What is the LFE input??? | AVS Forum What does the LFE stand for, and what does this input do? Can this be considered as the digital input of the subwoofer (not compressed) like the opticals and coaxials??? Click to expand LFE stands for Low Frequency Effects LFE effects are recorded in the the 1 channel in multichannel DTS, DD, etc recordings and is recorded at a higher DB
Large, Small, LFE, LFE+main, crossover settings confusion LFE = sub only plays LFE signal and from speakers set to SMALL below their crossover LFE+MAIN = only applies when front main speakers set to LARGE In addition to what the LFE setting does, the sub also plays the frequencies below the front main crossover setting (while front mains play full range signal)
Line In (L+R) vs. LFE - AVS Forum Line In (L+R) vs LFE Jump to Latest 12K views 19 replies 10 participants last post by badtlc Feb 17, 2022 S
LFE crossover - 80 or 120 Hz? - AVS Forum LPF for LFE - 80 or 120 Hz? Hi, I just wonder what is the recommended AV-receiver setting for "LPF for LFE" I e the Low Pass Filter (LPF) for the LFE subwoofer channel? Some say 80 Hz, others 120 Hz * If 80 Hz is selected, then won't the frequency range 80-120 Hz be filtered out, thereby
Subwoofer Cable connection: Single vs Dual RCA - AVS Forum I just installed a Yamaha RX-A8A AVR in my HT and ordered an SVS PB-3000 subwoofer Today, SVS advised me to get a single to dual RCA subwoofer cable because it can compensate for the "low LFE signal" that Yamaha AVRs supposedly put out I would take the subwoofer 1 output of the AVR and use the
When to use LFE+Main - AVS Forum Selecting LFE+MAIN allows the low frequencies from all speaker channels to be output to the subwoofer You would normally select this option when playing back PCM (2 channel) based audio Click to expand
In need of help setting up my SVS Subwoofer with my. . . If you enable the filter, the frequency setting will then become active again To recap: Set the subwoofer volume to -15 Set the subwoofer low pass filter to Off (LFE mode active) by sliding the toggle to the left Run set-up on the sound bar per page 27 and page 31 in their owner's manual Let us know how that sounds afterward