安裝中文字典英文字典辭典工具!
安裝中文字典英文字典辭典工具!
|
- Installing A 5-Point Harness Properly - Dragzine
Attaching these belts to your car takes some pre-planning and careful attention to the belt paths as they go over your body and to their fixed point The easiest way to install a set of harnesses is by using a snap-in system with Grade 8 eye-bolts
- What grade bolts for 5 point harness? - Polaris RZR Forum
Minimum specification for bolts and washers to attach the seat belts, harnesses and anti-submarine belt hardware are Grade 8 " grade 8 or 10 9 if metric I found the 12mm metric bolts to fit a little tighter (better) 2015 XP 1000 Grade #8, it's your life Don't cheap out on safety, over kill may provide "no kill" ?
- 5 Point Harness Install - Polaris General Forum
You'll need a 16mm (5 8) and an 18mm (3 4) wrench to take the bolts out of the stock mounting points There's an 18mm bolt that holds the retractor box in place that has to come out from the back "wall" of the cab
- 5 Point Harness Install - PRC Polaris Ranger Club
Remove both seats and storage pans The plastic needs to be cut away, easy enough Drill a hole big enough for the bolt that will hold the harness you purchased This is through the top frame rail of the seat A 2” to 2 25” bolt will be needed and a locking nut I needed a 1 2” bolt for my harness
- Harness Mounting Hardware - Aces Racing
Mounting Hardware for your 4 point or 5 point harness Grade 8 Bolt; Nylock Nut Yellow Zinc Plated 7 16-20 1" Includes 2 Bolts, 2 Nuts, and 4 Washers
- Mounting 5 Point harnesses to the floor - Hot Rod Forum
The angle of pull is all wrong Shoulder belts should be mounted even with the shoulders to a maximum of 4" below the shoulders Also, pay attention to the crotch strap mount DO NOT attach it at the front of the seat See the attached photo for proper 5-point belt installation
- Mounting a 5-point Harness - The Ranger Station
I have a 5-point harness that I am wishing to install in my 90 Ranger XLT I am curious as to how I should go about mounting the shoulder straps to the back of the cab The instructions that come with the harness specify that they should be mounted 0-10* below the shoulder; obviously I can not mount them at 0* due to a rear window and the fact
- How to mount 5 point harness? - Chevy Nova Forum
Basically, all you need is the bolt-in or snap-in tabs for the lap and anti-sub belts (just use the wrap around configuration through the mount tabs) Most use the bolt-in tab for the anti sub, and a snap-in for the lap belts if it makes mounting them easier
|
|
|