安裝中文字典英文字典辭典工具!
安裝中文字典英文字典辭典工具!
|
- Address ACI Fault Code F3696 Using coop-ep-dampening
Use this switch CLI procedure to view all dampened endpoints in a spine or leaf node Log in to the spine or leaf switch CLI and enter command: switch# show coop internal info repo ep dampening (Optional) Clear Frozen Endpoints
- Cisco ACI CLI Commands Cheat Sheet - Cisco Community
This document is formatted in the following way: commands are surrounded by <> in bold and possible user-given arguments within commands (if necessary) are surrounded by with a | in between multiple arguments Brackets [] will be used for mandatory verbatim arguments
- Cisco ACI Diagnostic and Troubleshooting Commands - routeleak. com
For leaf switches, you’ll find commands to track endpoints, check VLAN mappings, monitor interfaces, and troubleshoot routing protocols like OSPF, EIGRP, and BGP On the spine switches, key commands help verify COOP protocol data and detect dampened endpoints
- Cisco ACI troubleshooting commands - Prox blog
Spine commands Endpoints show coop internal info ip-db | grep <IP> -A 13 - display information about IP show coop internal info repo ep dampening - see the list of dampened EPs
- LTRDCN-2143 - Cisco
ACI provides a very easy way to find out where a particular EndPoint is located anywhere in the fabric The command is called show endpoints which provides valuable information from the EndPoints In this particular scenario, we will be troubleshooting POD04-WEB-SRV-02 If you recall from the previous section we left a continuous ping
- Effective Cisco ACI Troubleshooting Techniques | Orhan Ergun
You should check the configuration of the endpoints, including network settings, interface configurations, and any policies or profiles that have been applied You should also check for any configuration errors or inconsistencies
- Solved: Spine Endpoints - Cisco Community
Therefore, when you run the command on a spine, you will not see any endpoints since there are no endpoints connected to a spine If you would like to see a "global" view of all endpoints on all switches, you can run show endpoint command from the APIC
- Cisco APIC Basic Configuration Guide, Release 4. 2(x)
Use this Cisco Application Policy Infrastructure Controller (APIC) GUI procedure to clear and recover all dampened endpoints in a spine or leaf node This operation must be executed on all spine switches and on the source leaf switch of the endpoint
|
|
|