安裝中文字典英文字典辭典工具!
安裝中文字典英文字典辭典工具!
|
- NO CRANK ISSUE - TruckersReport
Follow that starter trigger wire backwards from starter You will have to cut open tape and loom You will only have to go less that 3 feet I have found the trigger wire broken in this area at least 10 times on a Cascadia Zip ties too tight is what causes it
- Zipties to lock chassis pins. - TruckersReport
The way some of the chassis pins lock in they will not come out because you don't have have a zip tie on it But some will I been pulling intermodal for a while so I can kinda look and tell the difference And I don't kno I never read it but they say it is DOT law to have zip ties on the chassis so take the chance of getting busted or the pins coming out Or simply put them on It's a 80%
- Air lines and wire loom - TruckersReport
Had a bit of chaffing on a ABS wire on my steer axle, replaced sensor then ran new sensor in wire loom and zip tied it to the air line for front
- 2019 LT with A26. SPN: 3216 FMI:10 Nox sensor. Where is it?
There are a couple of zip ties at the back to cut too Then turn the wheels to the left, remove the right side inner fender and you reach the rest of the zip ties and remove the sensor end from the outlet pipe
- Mud flap fix legality. - TruckersReport
He fastened it to the DOT bumper with zip ties The other mudflap on the other side was undamaged and normally fastened to the hanger I’m wondering if that’s legal and If I can do that temporarily in the future, as I have from time to time backed into potholes and curbs and messed up my mudflap
- Trailer air line support springs - TruckersReport
Back when I was a company driver drop and hooking 4-15 trailers a day I just use zip ties 1 Inform company of issue 2 Use 2-3 zip ties (beefy ones) 3 Ride on Reasons: zip ties will snap without damaging hoses when if tandems get slid to the rear
- What and where ia a Steer Angle Sensor? - TruckersReport
Inspect connector at the sensor for secure Suspect wiring issue or open sensor Sometimes tilt column can dislodge connector from sensor from zip ties to tight Also rotating column without steering shaft connected will break sensor internally Sensor is located below steering wheel Remove column covers front and rear to access connector
- 13 and 14 maxforce shutdowns solutions - TruckersReport
We find very often the wiring is too light and tied too tightly with too many zip ties that lead to broken connectors and shorted wiring as you mentioned I would like to see harness runner channels build into the design of the cab bodies, and engines and chassis to prevent wiring from chaffing and shorting out
|
|
|