安裝中文字典英文字典辭典工具!
安裝中文字典英文字典辭典工具!
|
- rs232 - What is the difference between RS-232 and RS-232-C . . .
The RS-232 Standard has gone through several revisions over the years In the original RS-232, the signal would flip between positive and negative 25 volts Since that point there have been three revisions, RS-232A, RS-232B, and RS-232C; these revisions lowered the acceptable voltage from 25 to 12 to 5 volts respectively
- serial - Electrical Engineering Stack Exchange
RS-232 defines two levels: 'mark' (logical 1) and 'space' (logical 0) The RS-232 to TTL converter inverts these to from the UART, so 'mark' is high at the UART and 'space' is low The UART framing state machine starts out by looking for the leading edge of the start bit, which is always a mark-to-space transition (high to low at the UART )
- serial - Difference between UART and RS-232? - Electrical Engineering . . .
A complete RS-232 interface will typically involve both a UART and an RS-232 level converter Further, the RS-232 standard includes the definition of several other signalling pins besides TX and RX, which you may need to use depending on the equipment you need to connect to These will also need to be level converted, and your UART may, or may
- Serial, RS232, Modbus, UART and TCP
RS-232 and RS-485 (and sometimes "TTL", for 0 8V 2 0+V levels) are physical implementations of a serial connection They define voltage levels for "high" and "low", and how devices are connected together A UART is the peripheral that implements a serial connection that follows the scheme described at the start
- communication - Electrical Engineering Stack Exchange
RS-232 is a very simple serial protocol that was originally used for modems and teletypes It is what is commonly called a serial port (or a COM port in MS-Windows) It is what is commonly called a serial port (or a COM port in MS-Windows)
- What is the difference between Ethernet and Serial communication?
At least three reasons, probably: In the era when RS-232 ports were common, it so by far the most common means of bit-at-a-time communication, so much so that the term "serial port" became synonymous with "RS-232 port"; using the term "serial" in connection with anything else would add confusion
- Force RS-232 DTR active - Electrical Engineering Stack Exchange
Regardless of the correct RS-232 name for this signal, following your update, it's pretty clear this is indeed an input Try any serial port on a laptop; such as a USB-to-serial converter; Try looking on an oscilloscope on TXD if necessary with so-called DTR asserted "manually" Assuming Machine Pin 1 is an input and it is actually RS-232 Levels
- Max Serial Cable Length? - Electrical Engineering Stack Exchange
RS-232 is an interface protocol It is not designed for long lengths; it is designed to connect endpoints to more capable communications equipment RS-232 allows you to connect to a modem that is not on your desk, but the one next to it, even if you have to run the cable high enough that people can walk under it
|
|
|