安裝中文字典英文字典辭典工具!
安裝中文字典英文字典辭典工具!
|
- Why do hams often conclude messages with 73?
The usage of "73" for such a purpose comes from the Phillips Code, originally devised in the era of telegraphs to speed up transmission of common messages by mapping them to numbers "73" mapped to "best regards" or "my compliments" and was intended as a general valediction for transmitted messages It is still used for that purpose today in morse code transmissions and often makes its way
- CW: when I supposed to send E E? - Amateur Radio Stack Exchange
I'm new to CW and one thing I couldn't figure out is when I supposed to send "E E" Let's say I'm calling CQ and somebody answers me The QSO is almost over Should it be ended like this: - TNX FE
- Whats the difference between saying “CQ” or “QRZ” in a contest?
The best thing to do is to listen for a while, and notice which stations are being responded to Sometimes operators will prematurely respond with their callsign, without waiting to hear if the other station has finished broadcasting, another bad habit It's about 80% timing and 20% luck! And, as always, good luck and 73!
- How does one read a ferrite datasheet? - Amateur Radio Stack Exchange
For example, Fair-Rite's 73 material: What's a $\mu'_s$ and a $\mu''_s$? What do these numbers represent, and how can I use them in amateur radio? Do they allow me to predict inductance or losses of inductors made on cores of this material? What is the relevant math?
- Coaxial Folded Dipole Antenna Matching Impedance
The site above depicts a regular dipole, with a simple matching system First, a bit about dipole impedance The impedance of a dipole is 73 Ohms at resonance, but away from the resonant frequency the impedance is different At frequencies lower than resonance, i e when the antenna is too short, it is capacitive, and its resistance is lower The Smith Chart is the usual way of plotting this
- How to estimate a dipole feedpoint impedance? - Amateur Radio Stack . . .
An ideal dipole, at resonance, will have an impedance around 73 ohms A folded dipole, around 280 ohms How can I calculate the impedances when not at resonance? Let's assume I have a span of 15M
- Impedance Matching Different Feedlines - Amateur Radio Stack Exchange
A folded dipole will increase this impedance to the square of the number of parallel elements (for the ultralite sr with 3 parallel elements, I calculate 9 * 73 = 657 ohms impedance)
- baofeng - Squelch breaks but no sound - Amateur Radio Stack Exchange
Otherwise, so you don't get frustrated just searching for frequencies, go to radioreference com and look for amateur radio frequencies and repeaters near you That will give you what you need to program your radio to so you can be sure to be successful Reach out to your local Clubs and they can help you 73 de WB4CDR Clint Jax, FL
|
|
|