安裝中文字典英文字典辭典工具!
安裝中文字典英文字典辭典工具!
|
- About – Elmer FEM
Elmer is an open source multiphysical simulation software mainly developed by CSC – IT Center for Science (CSC) Elmer development was initially started in collaboration with Finnish Universities, research institutes and industry After it’s open source publication in 2005, the use and development of Elmer has become international
- Unlisted Keywords in ElmerSolver - Elmer Discussion Forum
There are so many Unlisted keyword, and the simulation results are strange I have checked the Elmer Model Manual, and the * sif file is right Also I have seen the SaveGridData F90, I found the command I have used I have no idea where I have made mistake Thanks! Best Regards! Tan
- CoilSolver + MgDynamic solver - Elmer Discussion Forum
How to know if my Elmer version is having the correct CoilSolver version or not, as my Mageticfield and current density is still zero I updatd sife with component section definitions case sif
- EDF for new CoilSolver - Elmer Discussion Forum
I am loading the mesh *, from the zipped folder that you have provided, in Elmer While the mesh loads without a hitch I am not able to select the coil body inside the sphere by selecting its name under 'Body' tree Boundaries can be selected individually but the coil 'Body' name doesn't seem to be connected the the coil mesh
- ViewFactors - Elmer Discussion Forum
Hi we checked that the geometry is not open We use the trick with no emissivity on the side of the cave In certain cases the crystal is just 1 mm longer and the View Factor calculation fails
- Flux calculation in Simple diffusion does not work! - Elmer Discussion . . .
But we asked ELMER to calculate and save to a data file magnitudes such as diffusion flux, total mass inside the system and convective flow All of them are completelly off There is an unphysical convective flow in one of the surface (but velocity was imposed to be zero, convection was not calculated and NS equations were not solved!) which is
- Solution trivially zero when running MagnetoDynamics - Elmer Discussion . . .
I applied BCs to the "beginning" and the "end" of the copper winding to calculate the volume current based on a given current total This works fine, I can also see the resulting current in ParaView afterwards But when it comes to the magnetic field solvers, Elmer reports that the "solution is trivially zero" I have also attached my sif file
- How to merge the result files calculated by ElmerSolver_mpi - Elmer . . .
I am a beginner Elmer user I am using ElmerSolver to calculate the electric field structure and use the results for another simulation I would like to perform a calculation using ElmerSolver_mpi, but I am having trouble merging the split results I first executed ElmerSolver_mpi with the msh file created by Gmsh and the attached SIF file:
|
|
|