安裝中文字典英文字典辭典工具!
安裝中文字典英文字典辭典工具!
|
- Is Anycubic That bad? : r 3Dprinting - Reddit
Anycubic have had locked down firmware for years I bought one of their deltas in 2020 that came with chitu firmware on a trigorilla board At the time, it was impossible to flash it with Marlin unless you completely changed the mainboard Took a while but it was eventually cracked
- AnycubicOfficial - Reddit
r AnycubicOfficial: Welcome to the official ANYCUBIC community A place where Anycubic 3D printer users communicate, share, and help each other…
- Best settings for Anycubic Kobra 2 neo? : r anycubic - Reddit
Best settings for Anycubic Kobra 2 neo? Does anyone have any parameter suggestions to get good clean prints on anycubic Kobra 2 Neo? Like print speed, retraction, etc? Anycubic slicer doing fine but i feel the default Settings is messing with the quality print at 150 m ms I usually print figurines and such
- Anycubic kobra 2 pro adding a camera? : r anycubic - Reddit
Anycubic kobra 2 pro adding a camera? I have tried to add my Logitech c920 to the usb port but not sure how to get this camera to activate? Has anyone got a camera to work on the camera usb for the Kobra 2 Pro?
- Anycubic Kobra Neo: My review after 4 months : r anycubickobra - Reddit
The AnyCubic Kobra Neo was my first introduction to 3D printing and for that, I am grateful It made the job of simply turning on the printer and printing easier than anything I've read in the past with people having to manually set just about everything, so for that I am happy
- Anycubic Kobra standard - PETG cura settings : r anycubic - Reddit
Anycubic Kobra standard - PETG cura settings : r anycubic r anycubic Current search is within r anycubic Remove r anycubic filter and expand search to all of Reddit
- Giving serious thoughts to returning my Kobra 3 - Reddit
I don't think it is fair to compare it to an X1C - an A1 would be a more legit comparison And as I happen to have an A1, here's my view thus far: The Kobra 3 is faster Print quality is roughly equivalent The A1 is a little quieter but not much I really don't think the Kobra 3 is very loud Compared to my K1, it's whisper quiet Bambu slicer is just better, period Hopefully Anycubic
- Camera support is here? : r anycubic - Reddit
Works just fine from the mobile app Frame rate seems to be decent enough, and the video is only about 1 2 second behind I just put the camera on a tripod to see the bed and filament level, but will probably print a bracket for the camera and add some lights as well Thanks for adding the feature, Anycubic!
|
|
|