安裝中文字典英文字典辭典工具!
安裝中文字典英文字典辭典工具!
|
- policy-map definition of shape average and service-policy
'shape average' just means that all traffic (class default) going out through the WAN interface is 'shaped' to 10MB The value itself does not necessarily mean that the actual bandwidth available on your WAN is 10MB Shaping , compared to policing, is usually a better way to limit traffic
- Traffic Shaping on Cisco IOS - NetworkLessons. com
I work with Carrier Ethernet circuits that have policed Committed Burst Size variables If I understand this correctly, I should be to shape the traffic using shape average (CIR) (CBSx8) (EBS) x 8 According to MEF, a good rule of thumb for CBS is 8x mtu We typically have an EBS of 0
- QoS: Policing and Shaping Configuration Guide, Cisco IOS XE Release 3S
The following example configures traffic shaping using an average shaping rate on the basis of a percentage of bandwidth In this example, 25 percent of the bandwidth has been specified Additionally, an optional be value and bc value (300 ms and 400 ms, respectively) have been specified
- Configuring traffic shaping - Lumen
Use the examples below to learn how configure traffic shaping on devices for several vendors We recommend configuring a committed burst size equal to a 4ms Tc and an excess burst size equal to 0 bits (when applicable) Examples: The commands below configure the following settings and apply traffic shaping to interface FastEthernet0 1
- TCP Sawtooth, not getting upload speed with MT with PCQ, no problem . . .
We have problems with the upload speed of all the 50 50 Mbits lines of 1 ISP, download is fine After talks with the ISP and analyzing the packet captures, we discovered that there is TCP congestion Please see the image attached called TCP_SAW_50_50
- shape average vs. shape peak - Mostly Networking
If you use Cisco MQC and you need traffic shaping, you'll notice that the shape command has two variants: shape average and shape peak The syntax is: shape {average | peak} CIR [Bc [Be]] In other words: You have to decide whether you want average or peak, You have to specify CIR, You don't have…
- shape average command - Cisco Community
As far as I know there is no command like " shape average percent 28", at least on the platforms I worked with Will be glad to check if you have some docs for that So I think what will work is only this: shape avergae 25 bandwidth percent 26
- shape peak shape average - CSDN博客
The shape peak essentially allows you to use both the committed and excess rate every Tc interval, and you therefore get sustained CIR+EIR rate The shape average replenishes only Bc tokens per Tc interval Thus, the shape average 128000 allows you for sustained rate of 128 kbps However, after a longer period of low activity, when you
|
|
|