安裝中文字典英文字典辭典工具!
安裝中文字典英文字典辭典工具!
|
- Bowsprit replacement? - SailNet Community
My bowsprit is laminated with nine pieces, approximately 2 8” square, to form an 8” square The outside Stbd three of these are totally rotted for about 12” long The inner pieces are rotted only two laminations deep, about 17” long
- Retractable Bowsprit DIY - SailNet Community
Catalina Direct: Cruising Spinnaker Retractable Bowsprit Kit note that the kit is specifically recommended for the C27 I'm not suggesting that you should fly a monster chute off a 10' homemade sprit, but the benefits of a sprit are well documented and the sprit seems to be the future of sailing, especially when used with 'code' sails
- Adding a bowsprit to a sailboat - iboats Boating Forums
Re: Adding a bowsprit to a sailboat Thanks for that thought Is there any reason why you can't or shouldn't run a bowsprit on a sloop rig I understand about the new stay for the bowsprit and the bobstay It seems to me that it might make for better light wind performance to be able to run a larger genoa or a drifter on the forward stay
- Pros Cons of Bowsprit? - SailNet Community
A properly designed modern boat shouldn't require a bowsprit for the primary head sail For an asymetric, a retractable bowsprit is a good option, which will reduce your dock marina fees, as it is not a permanent increase in the LOA of the boat
- Bowsprit sizing question - SailNet Community
Ready to start the design of a short bowsprit to rig a light air genaker on a furler Have the load data from the sailmaker, curious if any engineering types can point me in the right direction I really like some of the retractable ones on the market, but it's not really necessary to retract, and they are a lot of money!
- TY 37 bowsprit drawing - SailNet Community
The Ty37 bowsprit is easy to rebuild as a DIY project The strakes are alternating teak and 'an unknown asian softwood' The rot is usually only in the 'softwood' and once disassembled and cross-bolts removed the bowsprit laminations will easily come apart with a few blows with a mallet (and chisel) to break loose the poor polyester 'glue'
- DIY Bowsprit - SailNet Community
Normally the bowsprit is located a little off center with the outboard end in the center line sugerpeople said: Is it worth it, or should I just attach the tack of the genaker to the tack of the genny (inside the forestay)?
- Retractable Bowsprit DIY | Page 2 | SailNet Community
-Tighten tack (done by hand) to pull the furler out on the end of the bowsprit-Hoist-Unfurl while taking in on active sheet If I need to use the spinnaker pole (normally light conditions DDW) -set spinnaker boom on mast-Put the windward guy in the jaw if the spinnaker pole-Adjust Topping lift Foreguy-Winch in on guy while easing tack
|
|
|