安裝中文字典英文字典辭典工具!
安裝中文字典英文字典辭典工具!
|
- Briggs and Stratton 17. 5 hp wont start and backfires
Hi! I have a 17 5 hp B S model number 31C707 that won't start It turns over fine and I have nice spark at the plug After cranking for a while, there's a
- B S compatibility (parts swapping) - Lawn Mower Forum
Briggs engines are in series or families with the same capacity Small Hp differences are done with carbs , big differences are done with bore stroke The easiest way to see if the heads SHOULD interchange is to check the part number of the head gaskets for each engine If it is the same the heads should interchange
- Intek v-twin valve adjustment procedures | Lawn Mower Forum
What valve adjustment procedures do you use on Briggs Intek V-twins? I'm aware of the factory procedure (setting each cylinder at 1 4" off TDC), but I'm curious to know how many are actually doing this versus setting them at TDC or setting one valve when the other is all the way open
- Briggs - Gas Blowing Out of Carb - Lawn Mower Forum
Briggs Engine 127802-0640-01 95091859 Carb has primer bulb Toro Push Mower Problem-Symptoms: 1 Engine starts and runs great for a few minutes and then runs "rough" for 15-20 seconds and then runs smooth for another minute or so and then runs rough again 2 After troubleshooting, I noticed
- Engine locks up and wont turn over (crank) - Lawn Mower Forum
I have to rotate the flywheel back and forth to free it up at which point the starter will engage and start the engine It doesn't happen often but when it does, the starter won't budge the engine The engine is an 18 HP Briggs Vanguard It has a new battery and solenoid but the starter is original Any suggestions would be appreciated
- Runs but doesnt rev up - Lawn Mower Forum
Hello again, i'm not sure if this is a problem from my other posts but i got my briggs and stratton mower running after a year or being stored in the shed I prime the carb 3 times as instructed and the mower starts as it should but its not reving up as it should It idles very low but it
- Briggs 17. 5 PROPER valve Adjustment method Debate
Hello all, Ok, watched 1000 videos and read a ton Can you guys tell me best way to adjust the valves on a Briggs single cylinder OHV engine? Debate is: Method 1- These people say set to TDC and a little past (engines with compression release) and then adjust both valves to specs Method 2-
- 22 HP VTwin Intek Mystery Fuel Issue - Lawn Mower Forum
I've run this engine for 9 years without issues until suddenly the carburetor flooded and stalled out the engine So I rebuild the carburetor nice and good and install it Ran strong the entire mowing session but when I came back to start it after weed trimming, I saw the plastic intake was
|
|
|