安裝中文字典英文字典辭典工具!
安裝中文字典英文字典辭典工具!
|
- Autosys job not starting based on starting time but starting based on . . .
1 Autosys job not starting based on starting time but starting based on dependency job condition
- Job stuck in loop condition due to NotRunning (Job) condition | AutoSys . . .
So we have a Autosys job (let's say JobA) that's stuck in a loop due to the condition NotRunning (jobA) So, the job continuously restarting itself, moving from STARTING state to RUNNING state, completing either in SU or FA restarting itself
- Where could I find the syntax and explanation for condition . . . - Broadcom
To support the look-back feature, you must add an additional operand to the condition statement You can apply the look-back feature to job status, cross-instance or external dependency job status, and exit code condition types only You cannot apply it to the global variable condition type
- when to use look back condition in autosys | AutoSys . . . - Broadcom
When i am studying the look back condition, its taking the last instance run of the condition or predecessor job Just want to know when to use this look back co
- look back condition not satisfied even if it is Success | AutoSys . . .
Hi there, FYI, I am new to autosys I am trying to use success (job_a, 01 00) condition, which I believe according to docs check if job_a is successsfull within the last hour or not right? But in autosys workload automation It is always showing condtion not satisfied May I know why? Does it depends on any other things I tested it by manually changing the status of job_a to Success But in
- Cannot migrate powered on VM | VMware vSphere - Broadcom
The virtual machine did not migrate This condition can occur if vMotion IPs are not configured, the source and destination hosts are not accessible, and so on Action: Check the reason in the event message to find the cause of the failure Ensure that the vMotion IPs are configured on source and destination hosts, the hosts are accessible, and
- I need to give a condition for IFgreater than or equal to condition . . .
For ex : I need to give a condition as IF SYS_TIME >= "000000"PRINT SYS_TIME ENDIFWhat is the correct syntax for the above in Automic?
- How to run a job multiple times in Autosys - Broadcom
condition: f (job1, 00 10) | f (job-r,00 10) alarm_if_fail: 1 Both jobs run the same command job-1 runs at 1am if it succeeds, great, we're done Then starting at 1:10 job-r will evaluate starting conditions and run if job-1 failed or moving forward through the start_times if job-r failed during that time period Hope this helps Regards, Mark
|
|
|