安裝中文字典英文字典辭典工具!
安裝中文字典英文字典辭典工具!
|
- LSI 9300-8i stopped showing disks [SOLVED] - Unraid
After a restart, my LSI 9300-8i HBA stopped showing disks I've had the card for almost 3 years, and it seems to have just stopped working After doing some diagnosing myself, I believe I've ruled out the hardware as being the issue, but I'm open to suggestions on further diagnosis if someone still believes it's a hardware issue
- LSI SAS 9300-8e HBA Not Displaying Drives | ServeTheHome Forums
Proper SAS Address corresponding to label on HBA is listed when showing running "sas3flash efi -list" I can get to the LSI Config Utility when booting in Legacy mode (doesn't show in UEFI) but when selecting SAS Topology, show no drives to display The exact same issue is ocurring with the other card running in the DL360
- Question LSI 930016i card and ROM Windows settings - AnandTech Forums
Once drives are actually connected to the LSI board, boot time is slooooooow Sometimes after a half hour I just turn off the pc None of the drives show up in File Manager or Disk Management, but depending on boot mode may show up in Device Manager weird (The Nvme C: drive always shows) I had to put my LSI 9311 8i and expander board back in
- LSI 9300-16i Not Recognized by Unraid
From your diagnostics, it looks like Unraid finds and uses the controller right, there are lines in the system logs about MPT3SAS being loaded, and starting the 3008 chip (which is your Broadcom 9300-16i), but the controller doesn't detect any drives You do seem to have one of the latest firmwares (16 00 10, there is a 16 00 12 on the internet) but it doesn't show or list if the BIOS is
- New issue. . . SAS drives not reading - Toms Hardware Forum
Went through all 12 SAS drives, unable to see any of them Switched ports on the controller card for the SATA and SAS cable Still able to see all 4 SATA drives and can't see SAS drives Attempted to remove SATA cable so only the SAS drives are on the controller, still no SAS drives show up
- LSI 9300-8i Will not show any Disks connected . . . - ServeTheHome Forums
My work buddy then had an old 6G adapter laying around with cables that also just took SATA power to power the drives, tried putting that in my home PC, and drives showed up perfectly, i then noticed the firmware on his card was IR, and thought the LSI 9300-8i i bought needed to be flashed with IR firmware, as when in my windows environment the
- LSI 9300-16i HDDs not showing up - Unraid
I was using the 92xx-8i and it was working fine but I have since upgraded to the LSI 9300-16i but none of the devices show up in the Unraid main dashboard in "unassigned devices" but I do see them in the System Devices section The devices also do show up in dev disk by-id as SCSI devices now a
- Reflashed LSI 9300-16i but still cant detect drives - Unraid
Bought a 9300-16i on ebay and used SAS3FLASH to change the firmware to a newer version See image Both controllers are on version 16 (previously it was 8 X X X), but I still can't detect any drives via the card Is there a newer firmware version I need to use, or do I need to change some settings in Unraid?
|
|
|