安裝中文字典英文字典辭典工具!
安裝中文字典英文字典辭典工具!
|
- Difference between IP route, eigrp, ospf, Ripv2. - Cisco Learning Network
Andrew schrieb: I want to know the difference between IP route, eigrp, ospf, Ripv2 I think, you mean "static routing" if you write "IP route" "eigrp", "ospf" and "ripv2" are routing protocols, that allow the routers in the network to lear ip routes dynamically (dependent of the available links, so if a link goes down and there is a possibility to reach the destination via another way, the
- EIGRP flapping - Cisco Learning Network
I have an topology as the below, both router run EIGRP There is a flapping as below: Sep 10 10:48:07 528 CST: %DUAL-5-NBRCHANGE: EIGRP-IPv4 405: Neighbor 10 102 1 110 (GigabitEthernet7 39) is down: Interface PEER-TERMINATION received
- How IP MTU mismatch impacts EIGRP neighborhood stability
What I've noticed is that the IOS that recognize the HWIC card have EIGRP version 9 0 2 0 running and the IOS where EIGRP is currently running have EIGRP version 5 0 3 0? I found this only: There are two major revisions of EIGRP, versions 0 and 1
- Cisco Learning Network
This feature is available only in EIGRP named mode configurations Classic mode configurations still use 32-bit calculations The 64-bit metric allows for more precise metric representation EIGRP Composite Cost Metrics: EIGRP calculates the composite cost metric using various vector metrics (bandwidth, delay, reliability, load, and K values)
- Cisco Learning Network
you must use the redistribute command under the EIGRP process inorder to inject the 0 0 0 0 0 route into EIGRP The network command only works for directly connected interfaces Inorder for the 0 0 0 0 0 default route to "appear" as a directly connected route you must use an outgoing interface rather than the NH ip address
- Cisco Learning Network
Sorry to interrupt Cancel and close This page has an error You might just need to refresh it First, would you give us some details?
- EIGRP - Split Horizon. . . - Cisco Learning Network
interface) , we need to disable split horizon to pass route across the spokes when EIGRP is used Yes, in Hub-Spoke Partial-Mesh topologies, whether using the main physical interface or multipoint subinterface, you should disable EIGRP split-horizon with the command "no ip split-horizon eigrp <asn>" command
- Redistribution and summarization between OSPF and EIGRP - where is best?
If I then go into the interfaces on the ASBR that are facing the EIGRP domain and summarize with the command ip summary-address eigrp 100 192 168 0 0 22 and then check the routing tables on the routers inside the EIGRP domain, I see my summary route but it is no longer listed as an external EIGRP route, it is now listed as D or standard EIGRP
|
|
|