安裝中文字典英文字典辭典工具!
安裝中文字典英文字典辭典工具!
|
- Faying Surfaces | Eng-Tips
I believe 'faying surfaces' only describes surfaces which come into contact in the assembled joint Flat face to flat face, e g What does faying mean to you that you are asking the question?
- Allowable gap in between faying surfaces of snug-tightened joints
As a result the modification, the beam is short and the faying surfaces of one of end-plate connections have 7 16" gap in between them The contractor has not used any shims Instead, they've tightened the bolts enough to deform the end-plates (with 7 16" gap still visible in the middle of plates)
- elctrical bond between faying surfaces - Eng-Tips
When applying the BMS595 sealant to the electrical faying surface, do you also cover the electrical bond area My interpetation of Boeing Spec BAC5117-6 Cat 2 is that you apply the sealant to the entire faying surface of one part I'm dealing with an aluminum assy and there is a bracket to be
- Washer a Faying Surface for Slip-Critical? | Eng-Tips
The Steel Manual describes Class A, B, C finishes on the faying surfaces A = Uncoated (plain) B = Coated (painted) C = Galvanized (spec Hot Dipped) From other literature I've gathered that the Class B has a higher coefficient of friction than plain or Galvanized So that made me wonder
- Galvanized Faying Surface - without wire brushing?!? | Eng-Tips
Any suggestions? A project with completed erection, with many connections designed as Class A slip critical The project is galvanized, so the coating is not Class A certified and the coatings are not blocked What can be done if the erector failed to wire brush the faying surfaces? The
- Theory question (fillet weld loaded perpendicularly to faying surface . . .
Suppose you have a steel box sitting on a steel plate with a force applied at the top perpendicular to the box The box is heavy enough that the load doesn't cause overturning and the friction force is large enough to prevent sliding Now suppose you fillet weld the sides of that box to the
- Eccentricity Normal to the Plane of the Faying Surface
Picture of case 2 attached Is 2*Rut supposed to be the maximum tensile force value for the tension bolt group? The formulas in 7-14b for just Rut Just verifying you would need to double that for max
- faying surface calculation - Eng-Tips
For those of you who may not know, a faying surface is the contact surface between two components Sometimes the faying surface will only comprise a portion of the total surface on each component I have stumped dozens of engineers at my work (Lockheed Martin Space Systems Company) in trying
|
|
|