安裝中文字典英文字典辭典工具!
安裝中文字典英文字典辭典工具!
|
- Recommended firewall settings - Network and Wireless Configuration . . .
If you pull up Network>Firewall what are the recommended settings for "General" and "Zones?" Upon reading google hits, many are showing a "Lan -> wan" setting of "reject" for forward whereas the out-of-the-box settings have that set to "accept" including this OpenWRT wiki
- Is there a place where I can see my firewall logs?
Hello, I am using openwrt latest (24 10 2) on a raspberry pi 4b I have firewall rule allowing incoming traffic to my webserver (only from my reverse proxy server) Is there a log file where I can see all the firewall allowing and blocking events? Thanks
- Firewall: functional difference between port forwards and traffic rules
Hello, I was following some tutorials for setting up a Wireguard server This one uses a port forward as follows: While the official OpenWrt tutorial advises to use the following traffic rule uci set firewall wg="rule" uci set firewall wg name="Allow-WireGuard" uci set firewall wg src="wan" uci set firewall wg dest_port="${VPN_PORT}" uci set firewall wg proto="udp" uci set firewall wg target
- How to block several outgoing ports in one firewall rule?
I'm trying to add a firewall rule to block several outgoing ports, I'm only able to add two ports in the source port field - any more ports and a warning comes up
- Firewall: Multiple Source and Destination zones - OpenWrt Forum
have to create 2 rule each for LAN (Main) and Guest Network even if they do they same thing foreach zone It would be nice to combine them into one Multiple Destination For example, Allow port 443 from lan to wan and vpn
- Firewall is running? - Installing and Using OpenWrt - OpenWrt Forum
The firewall is part of the kernel, it's not an independent process, and there is nothing running while the firewall is active What the firewall service does is to load the rules from the config files, configure the rules in the kernel, and finish
- Firewall zones forwards and rules - OpenWrt Forum
Hi all, I just installed OpenWRT, but I have difficulties understanding the relation and meaning of forwardings, firewall chains and rules I noticed that there are forwardings that define where traffic originating from a specific zone can be forwarded, but I also noticed that forwarded traffic must be accepted at the destination zone (only visible by editing a zone) Then there is the input
- Firewall block WAN connections to specific device
Hi, In my firewall rules I set a test rule for device A with mac-addr XYZ to block internet access These is the rule as it show in LUCI: Fowarded IPv4 and IPv6 From *lan*, MAC: XYZ To *wan* (Protocol any) Reject foward The device A has an update feature to fetch last release from github, so I try to get last update and it still was able to
|
|
|