安裝中文字典英文字典辭典工具!
安裝中文字典英文字典辭典工具!
|
- Firewall rule to allow incoming only from specific ip address
firewall rules Depends how much you trust the firewall on the VPS I'd probably put the VPN in its own firewall zone and use rules to allow forwarding
- [SOLVED] Firewall status: active with no instances
The firewall is operational (I know this because the device is behaving as it’s supposed to based on the firewall rules, including those I have put in) So I am wondering, what is the meaning of “active with no instances” in this context?
- OpenWRT LAN Routing and Firewall Setting
Windows firewall issue for subnet 192 168 124 0 24 Actually, Windows firewall issue was the first thing I thought about So I created an inbound firewall rule Home_Wu (upload: 4WzhZvsU1FKwquogv7iuylWkQkZ png) Please don' t mind the language Basically, it allows inbound traffic from subnet 192 168 11 0 24 and 192 168 101 0 24
- Disabling firewall features on AT T Arris BGW210-700 Gateway
I have an AT T Arris BGW210-700 gateway setup with IP Passthrough in front of my openwrt router Are these advanced options safe to disable with the default settings on openwrt’s firewall? Screenshot is the defaults but I want to turn them all off There’s also a toggle to enable the packet filter for the BGW210 which I have turned off
- How to stop “reloading firewall due to ifup of modem”
The firewall service reload should not cause connection reset Moreover, OpenWrt firewall depends on that reload to assign the zone properly Your issue is most likely due to the modem dropping connections by itself Unstable power, or too heavy load, or crappy firmware hardware, etc 1 Like Kode December 4, 2020, 9:07am 3
- Is there a place where I can see my firewall logs?
Hello, I am using openwrt latest (24 10 2) on a raspberry pi 4b I have firewall rule allowing incoming traffic to my webserver (only from my reverse proxy server) Is there a log file where I can see all the firewall allowing and blocking events? Thanks
- Firewall block WAN connections to specific device
Hi, In my firewall rules I set a test rule for device A with mac-addr XYZ to block internet access These is the rule as it show in LUCI: Fowarded IPv4 and IPv6 From *lan*, MAC: XYZ To *wan* (Protocol any) Reject foward The device A has an update feature to fetch last release from github, so I try to get last update and it still was able to
- Lets talk about firewall4 (default nftables firewall)
In contrast, service firewall restart does delete the fw4 table and then recreates it, and service firewall reload seems to check if anything has changed in etc config firewall and reloads as required So "restart" and "reload" are well behaved Why the big "I don't care about anything else" with service firewall stop ?
|
|
|