安裝中文字典英文字典辭典工具!
安裝中文字典英文字典辭典工具!
|
- What is the proper way to disable enable a firewall rule in a general . . .
Hi, I need to turn off this rule off (wait) then back on, automatically Now Luci did give me the command it uses uci set firewall cfg0e93c8 enabled='0' uci del firewall cfg0e93c8 enabled But these special number only work on that particular instance of my router, but I wipe it often, and these numbers will change I need a command that is "general" The rule is root@router:~# uci show
- Recommended firewall settings - Network and Wireless Configuration . . .
If you pull up Network>Firewall what are the recommended settings for "General" and "Zones?" Upon reading google hits, many are showing a "Lan -> wan" setting of "reject" for forward whereas the out-of-the-box settings have that set to "accept" including this OpenWRT wiki
- Wireguard Over Non-default Port - Custom Firewall Settings
Hi, I am trying to setup Wireguard to be used on some additional non-default ports like 53, 54, 443, etc , to be used with WG client (iPhone) over restricted wifi networks Currently my Wireguard client successfully connects over a single non-default port (51790) without any issues However, i want to be able to connect over the other ports as above in case of such scenario As per some online
- Firewall zones forwards and rules - OpenWrt Forum
Hi all, I just installed OpenWRT, but I have difficulties understanding the relation and meaning of forwardings, firewall chains and rules I noticed that there are forwardings that define where traffic originating from a specific zone can be forwarded, but I also noticed that forwarded traffic must be accepted at the destination zone (only visible by editing a zone) Then there is the input
- Firewall block WAN connections to specific device
Hi, In my firewall rules I set a test rule for device A with mac-addr XYZ to block internet access These is the rule as it show in LUCI: Fowarded IPv4 and IPv6 From *lan*, MAC: XYZ To *wan* (Protocol any) Reject foward The device A has an update feature to fetch last release from github, so I try to get last update and it still was able to
- [SOLVED] Firewall status: active with no instances
The firewall is operational (I know this because the device is behaving as it’s supposed to based on the firewall rules, including those I have put in) So I am wondering, what is the meaning of “active with no instances” in this context?
- Firewall rule to allow incoming only from specific ip address
firewall rules Depends how much you trust the firewall on the VPS I'd probably put the VPN in its own firewall zone and use rules to allow forwarding
- Disabling firewall features on AT T Arris BGW210-700 Gateway
I have an AT T Arris BGW210-700 gateway setup with IP Passthrough in front of my openwrt router Are these advanced options safe to disable with the default settings on openwrt’s firewall? Screenshot is the defaults but I want to turn them all off There’s also a toggle to enable the packet filter for the BGW210 which I have turned off
|
|
|