安裝中文字典英文字典辭典工具!
安裝中文字典英文字典辭典工具!
|
- Flashforge Adventurer 5M enclosure by ffontana - Thingiverse
Complete enclosure as tiny as possible and with multiple opening options I didn't like the official enclosure as I think makes the printer very big and has some kind of a toy appearance Original metal frame at sight (not bigger than de original frame) Front door can be left hand o right hand with hidden hinges (have to mirror some pieces) Upper window has multiple opening options also with
- (New version) Flashforge Adventure 5M Spool Holder - Thingiverse
This is a spool holder for the Flashforge Adenturer 5M because the spool holder it comes with it awful and doesn't even keep the spool from sliding off This is an update on my previous design for this holder The spool holding part is shifted 4cm or so to the side to reduce the stress on filament from spools that are close to empty I'm publishing it separately since the other one still works
- Cura Profile for FlashForge Creator Pro by Lyl3 - Thingiverse
Technical Details I followed the generic instructions at Adding new machine profiles to Cura I created two printer profiles (one for the left extruder and one for the right extruder) for the FlashForge Creator Pro as Makerbot style G-code, with origin at center, relative extrusion enabled, and set the crucial parameter defined for X3GWriter in the printer definition files:
- Has anyone had a jam yet? *Fixed! Thanks for the help!*
I recently just switched my ABS Extruder to PLA, did one successful print in the PLA then on my second print, around 85% of the print being complete (about an hour in) the extruder stopped feeding filament and there was quite a distinctive clicking sound I have tried upping the temps and pushing it through, also pulling it out and re loading but nothing is working Anyone got any tips on
- AD5X Partial enclosure by Arnookie - Thingiverse
Flashforge Adventurer 5x AD5X Partial enclosureThis will at least let you install the front door, I used acrylic panels attached directly to the sides, Still open topped but works ok
- FlashForge 5M+ Enclosure V3 by Rickeepalmer - Thingiverse
This is my remix of Flashforge 5M Enclosure This is my V3 which has a few remixes of community mods and some new parts Various alterations and additions:NEW Dragchain GuidesNEW Bottom GuidesNEW Middle RisersRemixed DK's LED Risers to suit Flashforge 5M and this enclosure mod 2 Dragchain versions including the 5m pro and a beefier bigger printable dragchain A different front power on off
- Help! PLA wont load after unload [Flashforge Finder] SOLVED
I have a Flashforge Finder and I was successfully printing, and unloaded filament without problems Then after I can't load new filament Tried some of the old filament, wont load either Any ideas? Have cleaned out feeder
- Flashforge Adventurer 5M filament cutter by ffontana
Small filament cutter for Flashforge adventurer 5M in order to have easier filament change (Don´t need to remove PTFE tube) Found several cutters on the web, but all of them were very big You would need: A pair of retractable ball pen springs (I used just one long enough to cut it into two pieces)A pair of 3x25mm screws 25mm of PTFE tube A piece of 9mm cutter blade (the small ones) The v1 has
|
|
|