安裝中文字典英文字典辭典工具!
安裝中文字典英文字典辭典工具!
|
- Question - CPU-Z vs Hwmonitor - Toms Hardware Forum
I have the core voltage set to 1 4 in Bios, however Hwmonitor shows 1 225-1 235 when in full load and 1 36-1 37 when in idle, CPU-Z on the other hand shows 1 37 in full load and 1 508-1 528 in idle Which is the real voltage? And is this good behavior of the voltage? I have an 11900k an z590 maximus extreme if it matters
- HWMonitor CPUID: What is CPUTIN, AUXTIN, SYSTIN and TMPIN3?
CPUTIN = CPU Temperature Index AUXTIN = Auxiliary Temperature Index SYSTIN = System Temperature Index CPUTIN is different from CoreTemp
- [SOLVED] CPUID HWMonitor temps ok? no idea how to read this.
Min (minimum temperature recorded since HWMonitor started) Max (maximum temperature recorded since HWMonitor started) I'm going to assume the temps above are whilst idle low load 30-35 degrees is very cool No issues at all Then under load you will want to keep them below 80 degrees effectively
- What is utilization limit and power limit in hwmonitor under . . .
Hello i have a gtx 1070 fe edition and i was playing witcher 3 for 1 hour the max temp of cpu is 49 so great on the gpu it is 78 at max i dont knoe if it is good or no i mean hot or no but from what i know it is a good temp and normal for the fe edition card but now what is the utilization limit
- HWMonitor Readings (CPU temps vs Package temps?) - Toms Hardware Forum
So I just overclocked my FX-6300 to 4 2GHz @ 1 3v (not final, hoping to get it higher), and I did a quick stress test using Prime95 to check out the temps (using HWMonitor), and to make sure it's somewhat stable When I started the test, I quickly found out that I wasn't sure what to look at for
- [SOLVED] Good hardware sensor monitor? - Toms Hardware Forum
Utilities like HWmonitor, Openhardware monitor and Speccy, tend to COMMONLY misreport sensor data, or not report it at all After installation, run the utility and when asked, choose "sensors only" The other window options have some use but in most cases everything you need will be located in the sensors window
- [SOLVED] Which temp program should I trust? - Toms Hardware Forum
HWmonitor, Open hardware monitor, Realtemp, Speccy, Speedfan, Windows utilities, CPU-Z, NZXT CAM and most of the bundled motherboard utilities are often not the best choice as they are not always accurate Some are actually grossly inaccurate, especially with
- Have any experience with HWMonitor? - Toms Hardware Forum
Any piece of software might have a glitch with a particular chipset; to me, unless there was some known issue with an HWMonitor and the X79 chipset (doubtful, as one would suspect the software would have been corrected many years ago,as the X79 board was is widely used for the last 8 years), it is (in my opinion) more likely a motherboard sensor sensor path issue (or even a missing sensor that
|
|
|