安裝中文字典英文字典辭典工具!
安裝中文字典英文字典辭典工具!
|
- Changing audio input on DSD+ - RadioReference. com Forums
Having issues piping audio from SDR# to DSD+ on my laptop On my desktop, it works fine because DSD recognizes the VB cable as the only audio input source On laptop, the laptop microphone appears as audio input device 1, so no audio comes through to DSD Otherwise, SDR sharp works good
- Confusion about input output tone vs. Transmit Receive
Input is the repeater receive frequency and the user radio transmit frequency Output is the repeater transmit frequency and the user radio receive frequency In Baofeng radio menus: T-DCS is transmit DCS (or DPL) T-CTCS transmit CTCSS (or PL) R-DCS is receive DCS R-CTCS is receive CTCSS Click to expand
- Input vs Output Frequencies - RadioReference. com Forums
Maybe dumb question, but I'm trying to program Dallas County Skywarn frequencies in my scanner and in the RR database there are Input and Output frequencies listed Which do I program? Is Output if I were "Transmitting"? Any thoughts? Thanks
- Different Input and Output tones - RadioReference. com Forums
The Inyo County, California Sheriff's Department uses two different repeater pairs and each has output tones which differ from the input tone There are a few 6 meter ham repeaters in the west which use different tones between output and input
- Input Frequencies - RadioReference. com Forums
Just to clarify right away I understand the difference between input and output frequencies, for the most part Recently I was parked across the street from the HQ of my City's police department and managed to pick out another frequency besided the two repeater freqs I already have Now
- BCD325P2 BCD996P2: - No GPS Input | RadioReference. com Forums
So I just hooked up my BCD996P2 with a BC-GPSK antenna, but my unit states 'No GPS Input' I have checked and the system is getting power, ground is good, port set at 4800bps, yet this thing doesn't want to work Any ideas?
- DSD plus audio inpiut - RadioReference. com Forums
I am just not able to change the audio input device I am using the following command [-i1M], but instead of a change to the correct audio input, I get
- tone settings in CHIRP? - RadioReference. com Forums
I'm trying to program a Baofeng radio to match existing (commercial) radios, using CHIRP But I don't understand what all the "tone" columns in CHIRP mean Tone Mode, Tone, Tone Sql, DTCS Code, DTCS Rx Code, Cross Mode I know generally that's setting different tone codes, but all I have to
|
|
|