安裝中文字典英文字典辭典工具!
安裝中文字典英文字典辭典工具!
|
- Input vs Output Frequencies | RadioReference. com Forums
"Input" refers to transmitting radios' traffic going "into" the repeater to be rebroadcast out; "output" means traffic that's coming out of the repeater going out to listening radios So program the "output frequency" in to monitor on a scanner
- Frequency setting in CHIRP software . . . - RadioReference. com Forums
I am beginning to use the CHIRP software and am confused by the "memories" entries I am trying to input this repeater spec: TX 467 5000, RX 462 5000, PL TX 127 3, PL RX None (which makes perfect sense to me ) However, in the CHIRP "memories" interface, there is only a single entry
- Palomar 225 input output - RadioReference. com Forums
Above the relays is a carrier sense transistor (2N3904 or 2N3906, depending on the exact circuitry) that is used to switch from RX to TX You should be able to follow the components from the "RF-Input" connector, through the relay, and to that transistor One half of that relay switches the input and the other half switches the output
- RX TX So confused | RadioReference. com Forums
If there are two different frequencies listed, the agency mobiles listen to the frequency listed in the first column but transmit on the second, different INPUT frequency (duplex operation) into the agency's repeater The repeater then repeats everything it hears coming in on the INPUT frequency back out on the first main frequency This allows
- DSD plus audio inpiut | RadioReference. com Forums
I am just not able to change the audio input device I am using the following command [-i1M], but instead of a change to the correct audio input, I get : IMBE unvoiced audio set to 40 I am sure this is one of the typical newbie questions, but I am a bit lost and ask for help 73 Willi
- tone settings in CHIRP? | RadioReference. com Forums
I'm trying to program a Baofeng radio to match existing (commercial) radios, using CHIRP But I don't understand what all the "tone" columns in CHIRP mean Tone Mode, Tone, Tone Sql, DTCS Code, DTCS Rx Code, Cross Mode I know generally that's setting different tone codes, but all I have to
- R8600 10 MHz ref input level - RadioReference. com Forums
The Icom manual states that the required 10 MHz input is -10 dBM I have wondeered about what an acceptible level would be as well Looks like 0 dBM should be OK I would have thought that at this price level, they would have used a nice OCXO, but they used a TCXO instead I guess they didn't want users to have to wait for warmup
- DSD+ - No Audio output | RadioReference. com Forums
PROBLEM SOLVED! The DSD+ plugin saved my day Looks like my "Input Output" settings were not correct And now I am able to copy the digital signals identified as DMR (DCC 6) Now trying to understand the log messages seen on the DSD+ command window and on the DSD+ Event log window
|
|
|