安裝中文字典英文字典辭典工具!
安裝中文字典英文字典辭典工具!
|
- ARP request has destination MAC: 00:00:00:00:00:00 - Cisco Learning Network
Hi Duchm, Thank you for the feedback From your response what i understand is: MAC:00 00 will be used by ARP when they want to know the MAC address of the destination The [Is gratuitous: False] means that this is not a gratuitous ARP request as it is not doing any announcement (to avoid duplication) Please confirm if i understood correctly Regards, Ruchit
- What could these IP addresses with MAC: 00:00:00:00:00:00 be?
Flags 0x0 and HW address of 00:00:00:00:00:00 mean it is a failed ARP To test ping an unused IP address on the local network and then relist That IP address should now also show in the output of cat proc net arp Can also use the arp command which should show (incomplete) for the HWaddress for the IP addresses in question
- Convert Timestamp 00:00:00. 000 into total seconds AND milliseconds
I have the problem that I am left with a timestamp that reads like: 00:02:02 300 meaning: hours - minutes - seconds - milliseconds and need to desperately convert it to total seconds That is tri
- What is the mac-address of multicast (ipv6) - Super User
Ethernet has "multicast" MAC addresses as well – any MAC address with the "group" bit set is technically a multicast address; IPv6 uses the prefix 33:33:*, while IPv4 uses 01:00:5e:* There are other widely-used prefixes, see this Wikipedia table for details For IPv6 multicast addresses, the last 32 bits of the IPv6 address are OR'd with 33:33:00:00:00:00 For example: The "all nodes
- hdparm error: SG_IO: bad missing sense data - Super User
I'm trying hdparm in Kali Live to add a ATA password to my Micron M600 Self-encrypted SSD, I use: hdparm --security-set-pass PASSWORD sda But I get: sda: Issuing SECURITY_SET_PASS command, passw
- How to write time in excel in the format 00:00. 00 - Super User
The default time format of Excel varies depending on your Locale To change it, select a range, then right-click and choose Format Cells, which should open on the Numbers tab (choose Numbers if it does not) Then, choose Time in the left pane of the dialog box, choose the desired format in the right side pane, then click OK
- Packet received with invalid source MAC address
Luis maybe correct, but before changing port, check the port status of the other end connection port Also, you can confirm if both port end are on the same duplex mode The other end port is sending an invalid MAC address packet to your 4500 Gi1 10 port Likewise, confirm if you dont have a security breech, like packet sniffers Try and clear counters on the two connecting ports Lastly, you
- hdparm errors: bad missing sens data (no hdparm commands working)
No, hdparm is simply the wrong tool for your disks They are SCSI (SAS) disks and you are trying to use a program that is entirely built around ATA commands They literally do not speak the same language For SCSI you have sg_* tools found in sg3-utils For example, sg_inq to show disk identity, sg_start to spin up down, sg_turs and sg_requests for status The usual smartctl will work with
|
|
|