安裝中文字典英文字典辭典工具!
安裝中文字典英文字典辭典工具!
|
- Soldering Station, JBC, Ersa or Weller (Update: I´ve bought a Weller . . .
Not being able to change tips quickly is not entirely true It depends on which Ersa station you are using My recommendation would be to go for the 'older' Ersa RDS80 soldering station and the 80W basic tool that can use the 832 842 series of tips
- Weller WMD-3 soldering station. Questions around tools and . . .
EternalEngine: No, the Weller WMD 3 supports only 24 V tools up to 150 W The WMRT (and WMRP) are 12 V tools and work only on select stations
- Weller and Soldering Stations Questions - Page 1 - EEVblog
Hello Guys, This is my first post, I have done a lot of research on soldering irons and stations, and have come to the final choice for a budget, Hakko FX888D and Weller WES51 Personally I liked Weller WES51 the most, but Its very hard to get one in Portugal
- New Soldering Station Recomendation Weller VS JBC VS Ersa VS . . . - EEVblog
Re: New Soldering Station Recomendation Weller VS JBC « Reply #21 on: November 28, 2016, 10:19:43 pm » For me going back to ersa, weller or metcal (I have access to and can use all three of them) after using my trusty jbc for more than 9 years would be like saying I was too bored with a ferrari and decided to get a VW for a change
- How good is a Weller Soldering Station? - Page 1 - EEVblog
Hi Im looking for a good soldering station for my studies, but I also want it to last more than that Right now im looking at this weller station, is it to much ? is it appropiate? 1-channel welding station with 70W soldering iron with ergonomic handle and safety support ESD safe station, heat and iron resistant silicone cable for safe handling
- Weller Soldering Iron WES51 - Page 1 - EEVblog
The soldering station is acting like the thermocouple is open when cold and AC mains hum there gets it to start and once hot the thermocouple sort of works and is no longer an open circuit Does the red LED+PIC work? It's red only for "unlocked mode" when the reed switch is activated
- Repairing a weller soldering station - Page 1 - EEVblog
Re: Repairing a weller soldering station « Reply #2 on: May 09, 2018, 12:52:10 pm » Unless you are buying the 230-110 v transformer anyway I would hold off until you open it up and look for visible damage
- Weller WE1010 Stopped working and troubleshoot - Page 1 - EEVblog
Hi anyone using weller WE1010 soldering station? I have this unit (my mains is 220VAC 50Hz so I use it with a 220v-110v step down converter) and suddenly it stopped working So I opened it up and did the following tests: 1 transformer primary side shows 8 Ohm, secondary side shows 0 5 Ohm resistance 2 Secondary Polyswitch and Fuse was good 3
|
|
|