安裝中文字典英文字典辭典工具!
安裝中文字典英文字典辭典工具!
|
- Motor and ESC question | Electronics Forum (Circuits, Projects and . . .
In Ltspice it shows producing required signal, almost (50 Hz, duty 5% to 10%) with the variable R (R5=10k) But when I made and tested it practically the ESC ( motor) not running giving err tone
- Circuit simulator | Forum for Electronics
LTspice is a widely used circuit simulator that is available for free from Analog Devices It includes a large library of components, including capacitors, inductors, and resistors, and can simulate both initial and steady-state conditions of RLC circuits
- Modelling a Resistance Transferfunction in Tina - All About Circuits
It is an undocumented feature in LTspice Resistors Behavioral Resistors Create a behavioral resistor by right-mouse-button clicking on its Value field and edit its value to read: R=<expression> This feature is undocumented, but is considered permissible to use
- how to find switching losses in LTSpice - Forum for Electronics
The LTspice model takes about 40nC of charge to change Vds from 0V to 600V The energy required is that multiplied by the bus voltage, which is 40nC*600V=24uJ This happens twice per switching period (once for each edge), and for each half bridge, so combined switching loss across all four FETs is 96uJ*Fsw 2
- LTspice run slowly - All About Circuits
Hi, I've been working with LTspice, and found that many times the simulation get very slow, in fact - not useable Can anyone help with that? I've tried several solutions (see below) but it didn't work Please see attached two simulation project examples: 1 LED driver (LT3474) with and without
- LTspice - Closed control loop for LLC converter - All About Circuits
Hello everyone, I've got an assignment to design LLC converter and I would like to control it with a closed feedback loop The resonant circuit works fine I designed the converter so that it has constant 100 V output, maximum output current is 10 A My assumption is that the input voltage can
- PMOS LTSpice issue - All About Circuits
I'm seeing a problem with my project on LTSpice The PMOS circuit is powered by 14VDC and is using a 2n3904 to switch the Gate on the PMOS The gate is going from 14v to 0 v, but the Drain is only going from 13 98v to 13 38v Can someone tell me why this is happening?
- LTSPICE - How to specify capacitor initial condition - All About Circuits
How do I specify the initial charge voltage of C4 like that of C3? Right clicks on C3 C4 both popup the same menu with options like capacitance values and Rser(ESR) On C3, the change I made to Rser is seen on the schematic but on C4 the Rser value I entered don't even show up on the
|
|
|