安裝中文字典英文字典辭典工具!
安裝中文字典英文字典辭典工具!
|
- Solved: MX100 Replacement - The Meraki Community
Hi, The MX100 doesn't go EOS until Feb 1, 2027, but I am doing some budgetary planning and am considering the MX85 or MX95 I've looked at the MX Sizing Principles document, but was wondering if Meraki can pull any statistics from the existing MX100 to help in sizing a new MX? The only limit on th
- Solved: MX100 WAN Throughput - The Meraki Community - Cisco Meraki
Tested yesterday to connect directly to the fibre to Ethernet converter and thus omitting the MX100 and then the bandwidth to the Internet was 850 Mbit s down and 936 Mbit s up on the 1 Gb connection we are paying for When connected to the MX100 it got down to 382 Mbit s dow and 394 Mbit s up So more than half of available bandwidth is lost
- Replacement Product of Meraki MX100-HW - The Meraki Community
We are currently using two Meraki MX100-HW appliances configured in an active High Availability (HA) setup One of the MX100-HW units was recently sent for warranty RMA, and Meraki has offered an MX95-HW as the replacement, since the MX100-HW has reached its End-of-Sale (EOS) status Given this replacement, we would like to clarify the following:
- Using MX100 SFP port as Internet Port - Cisco Meraki
It should include only the one SFP and one RJ45 port at the right hand end of the MX100 The IP then goes on the WAN interface that the green cable above goes to If my answer solves your problem please click Accept as Solution so others can benefit from it
- mx100 license - The Meraki Community - Cisco Meraki
Looking at CCW you can still quote the part code LIC-MX100-ENT-1YR I can’t however find MX100-HW So I would say the EOS applies only to the HW otherwise Meraki and it’s customer base would end up with a series of doorstops out in the field if you couldn’t buy the Licences (which is your entitlement to support)
- Meraki MX100 replaced for MX 105 - The Meraki Community
I need to migrate the Meraki MX100 to the MX105 Which is the best strategy? I'm not sure Clone the network or incorporate those MX 105 into the existing network There are 16 switches and 96 access points in the existing network I think the best course of action is to integrate those MX105 into the existing network, isn't that right?
- Replacement Product of Meraki MX100-HW - community. meraki. com
We are currently using two Meraki MX100-HW appliances configured in an active High Availability (HA) setup One of the MX100-HW units was recently sent for warranty RMA, and Meraki has offered an MX95-HW as the replacement, since the MX100-HW has reached its End-of-Sale (EOS) status Given this replacement, we would like to clarify the following:
- Reset configuration on MX Appliance - Cisco Meraki
I want to reset the configuration on my MX100, there's no obvious way of clearing the configuration Would removing and deleting it from my inventory clear the cached config and settings? I still would be using it in the same dashboard, just on a different network
|
|
|