安裝中文字典英文字典辭典工具!
安裝中文字典英文字典辭典工具!
|
- MBRP Catback Installed - Welded and Extended
The passenger side exhaust actuator connector wiring had have its retainer clip disconnected to allow connection to the actuator when mounted on the MBRP catback The wiring was pulled tight here and is just long enough to connect - I will probably need to extend the connector wiring on this side to accommodate my 11Mode controller
- MBRP vs SLP vs JAWS Cans??? | SnoWest Forums
Mbrp can lost rpm on my buddies axys like 200 rpm Put stock back on and gain the 200 rpm back jaws and slp can never made a difference in rpm
- Mbrp can on an 850 | SnoWest Forums
Anyone had any trouble with the mbrp race can on etec 850? Found a good deal on one, just wondered if they have any problems with them Or runability issues Temp sensor issues?
- 3. 3TT - MBRP Catback with downpipes - Droning - MBRP resonators install?
Anyone have the MBRP catback with downpipes and install the MBRP resonators to eliminate the droning? How did it come out? I have the MBRP catback with Ultimate performance primary and secondary downpipes and the droning is absolutely unreal
- MBRP Can compared to GGB | SnoWest Forums
How does the MBRP trail can compare to the GGB trail can, which is quieter, which is the best quality, which runs the best on XM 800 Etec? I have heard the MBRP trail cam and it is no louder than stock until about 7200 RPMS then it is a little louder than stock, but sounds good
- MBRP or not | Kia Stinger Forum
I love the MBRP sound at WOT, but the tradeoff is a noticeable resonance (drone) under medium engine load, especially around 2200rpm It's not too bad, but I'm still considering fabbing up some J-tubes to maybe tune it out You're definitely gonna want tips Any sporty exhaust is going to be louder in the cabin, especially in a hatch like the
- Finally an MBRP Race Can | SnoWest Forums
I have been using MBRP products for 7 years now and still have a machine that I put one on in 2007 and the can is in perfect shape (over 5,000 miles) In the past MBRP has made some noisy cans but with the greenies cracking down MBRP has jumped on board and adjusted their sound levels to be more acceptable for the times
- slp pipe w mbrp can on m1000? | SnoWest Forums
I ran an mbrp can with a d d y-pipe pipe combo and had a nasty bog on the bottom end The reason for this is the MBRP has no back pressure what so ever and doesnt let the pipe do it job, blows fuel out the can An mbrp can is best on a stock y-pipe and stock pipe combo I switched my mbrp out for a trail barker D D can and got major gains
|
|
|