安裝中文字典英文字典辭典工具!
安裝中文字典英文字典辭典工具!
|
- TIPM issues and replacement advice | Dodge Nitro Forum
Hi everyone, I'm having some really strange issues with my 2007 Dodge Nitro SLT (3 7 V6) I'm pretty confident that the issues are all tied to the TIPM, but I need help figuring out the best way to get it replaced I'm also concerned about finding the right part for my vehicle as well as
- starting problem, keep cranking for long time. . . . - Dodge Nitro Forum
Hello I am a new Canadian member to the Nitro forum family I have an 08 Nitro R T, and was having the same crank issues as other members First we changed the crank sensor, after about a day the problem came back We then changed the cam sensor, its been about 2 wks and haven't had any crank issues since Hopefully this helps somebody out there!
- Spark Plugs And Firing Order - Dodge Nitro Forum
New guy to the forum I am having P0305 and P2314 code coming up on my 2009 Dodge Nitro RT So far changed plugs and still runs rough Cylinder 5 is all black Plug looked fine Any help would be greatly appreciated
- Daystar 2 lift pics and thoughts on the install. - Dodge Nitro Forum
Whatever the cause, the angle the upper ball joint sits at will limit off roading After hitting the trail last weekend, I developed a clunk from the driver side I took the Nitro into the alignment shop a few days before I went out and I asked them to check the torque specs for me They obviously missed the upper ball joint on the drivers side
- PCM wire and connector location | Dodge Nitro Forum
I have a 2011 Dodge Nitro SE 4WD 3 7, and the Engine lights are on, showing PO300 I replaced ALL spark plugs, the ignition coil, the spark plug wire, the fuel injectors, and even the EGR valve However, the engine lights are still on; could it be the ECU sending the signal?
- ABS, ESP BAS Traction Control lights on | Dodge Nitro Forum
2007 Nitro SXT w 3 7 motor 93,000 miles ABS, ESP BAS Traction Control lights on Jump to Latest 63K
- 2011 Nitro 4. 0 temp sensor | Dodge Nitro Forum
Yes, the location makes replacing the coolant temperature sensor challenging I just replaced that sensor on my Nitro, along with the thermostat It was the original plastic one but I was fortunate and got it out in one piece But I broke off the head of one of the thermostat bolts, and took me one week to get it loose
- How To: Replace Fuel Injectors in 3. 7l Engine - Dodge Nitro Forum
Injectors for the 3 7l are available from many different manufacturers I believe 22# is the generic specification After some research I found the ford bosch XF2E-C4B is what many jeep 4 0l (older inline 6, not the optional Nitro 4 0l v6) owners install as a replacement for the "sub par" units that came from the factory
|
|
|