安裝中文字典英文字典辭典工具!
安裝中文字典英文字典辭典工具!
|
- OSPF process ID - Cisco Learning Network
If the OSPF process numbering is inconsistent on PE routers in the MPLS VPN, the domain-id OSPF mode command should be used to mark that the OSPF processes with different numbers belong to the same OSPF domain This means that, in many practical cases, you can use different autonomous system numbers for the same OSPF domain in your network
- Chapter 4 - Segment Routing | OSPF - Cisco Learning Network
router ospf 1; router-id 9 9 9 1; area 0; interface Loopback1; passive enable! interface GigabitEthernet0 0 0 3; network point-to-point; commit; end; Part VIII: Chapter 3 - Segment Routing | Disjoint Paths Part II: Chapter 4 - Segment Routing | N and E flags Part III: Chapter 4 - Segment Routing | OSPF SR Mapping Server Part IV
- What is ospf priority? - Cisco Learning Network
Priority in OSPF is mainly used to influence determine a designated router backup designated router for a network By default, the priority is 1 on all routers A router with a high priority will always win the DR BDR election process
- Cisco Learning Network
OSPF By default, OSPF uses a 10-second hello timer and 40-second hold timer on broadcast and point-to-point links, and a 30-second hello timer and 120-second hold timer for all other network types An interface's hello timer can be adjusted: Router (config-if)# ip ospf hello-interval
- OSPF E2 and E1 routes - Cisco Learning Network
Hi guys, Yeah, I'am referring to this So E2 routes with same seed metric almost behaves like E1 While it is technically true that “OSPF routers do not add any internal OSPF cost to the metric for an E2 route”, both the intra-area and inter-area cost can still be considered in the OSPF path selection regardless of whether the route is E1 or E2
- OSPF: Why use Loopback over Router-ID - Cisco Learning Network
From the Cisco OSPF Design Best Practices: Router id •Configure a deterministic router ID for OSPF process, using router-id command •Choose the router ID (IP address) from the same OSPF area address space the router belongs to This helps in route summarization, in case these router IDs need to be routed
- What is process id in ospf? What is its exact use and benefit?
In OSPF (Open Shortest Path First), the Process ID is a locally significant identifier used to distinguish different OSPF routing processes running on the same router It is specified when enabling OSPF using the command: router ospf <process-id> Exact Use of OSPF Process ID: Differentiating Multiple OSPF Instances:
- Cisco Learning Network
Hi Nima, Age column shows the age of the last received LSA, if a newer copy of that LSA gets recieved you would see that the age would be reset to zero and its sequence number would be incremented as well MaxAge instead is 1 hour by default and cannot be changed, if any LSA reaches the maximum age it would be flushed, to prevent the valid LSA from reaching its maximum age so being flushed
|
|
|