安裝中文字典英文字典辭典工具!
安裝中文字典英文字典辭典工具!
|
- How to Fix the Line is Slightly Off Axis and May Cause Inaccuracies . . .
If you’re a Revit user, you’ve probably encountered the “Line is slightly off axis and may cause inaccuracies” warning at some point in your project While it may seem like a minor issue, it can lead to significant problems, especially when you’re working with complex models or preparing for documentation
- Warning about the “off-axis” elements appears when . . . - Autodesk
There is a warning "Line in Sketch is slightly off axis and may cause inaccuracies " when Project North is rotated in Revit Every line, wall, grid etc that is drawn has a slight offset about the “off-axis” elements
- Element Is Slightly Off Axis - Autodesk Knowledge Network
Issue: The problem can be caused by sketching or rotating elements when angle snaps are turned off, or it can result from pre-existing elements when you do any of the following: Create an element by picking a slightly off-axis face or line Align an element to a slightly off-axis reference
- The beam is slightly off axis - SOLVED - Revit Forum
So I was trying to figure out a way to stop Revit from throwing the warning the beam is slightly off axis and I think I cracked it It has to do with the snaps For some strange reason if you use the defaulted nearest snap (without overrides) it will throw a warning
- Line is slightly off axis and may cause inaccuracies.
Line is slightly off axis and may cause inaccuracies I get this error message whenever I try to do anything that requires drawing lines in 90-degree angles such as creating mass, subsurface, detail line, model lines, etc
- Solving Revits Element Slightly Off Axis Floor Warnings with Dynamo . . .
Our custom Dynamo script tackles this problem head-on by automatically identifying and correcting off-axis floor elements Here’s how it works: Identification: The script scans your Revit model for floor elements triggering the off-axis warning Analysis: It calculates the deviation of each problematic floor from the correct axis
- Element Is Slightly Off Axis warning when placing or . . . - Autodesk
The warning message "Element Is Slightly Off-Axis" pops up when placing or importing an element in Revit This warning is triggered by elements based on lines that are misaligned —by 1x(10^-9) to 2 degrees— in either the horizontal or vertical directions, or with a line at 45 degrees to the horizontal vertical direction
- How to Fix Off-Axis Grid and Wall Warnings in Revit with 1 Click . . .
Are you dealing with the frustrating "Line is slightly off axis and may cause inaccuracies" warning in Revit? In this video, I’ll show you how to fix these off-axis grid and wall warnings
|
|
|