安裝中文字典英文字典辭典工具!
安裝中文字典英文字典辭典工具!
|
- polling rate on keyboard :: Hardware and Operating Systems
- 3, set the USB polling rate to 4 millisecond - 4, set the USB polling rate to 8 millisecond - BIOS, allow you to turn of certain advanced features in trade of compatibility with certain Motherboards Switching to different mode will disable the keyboard for few seconds before it can be used again, while your operating system detects its driver
- Polling Rate of Mouse? :: Hardware and Operating Systems - Steam Community
Polling rate for either mouse or keyboard should be 1000Hz, unless you PC is very old and can't support that, in which case 500Hz This is however regularly the device will check for updates 1000Hz would be 1000 times per second the processor queries your mouse As you can see it's a lot, and between 1000Hz to 500Hz, you won't tell much
- Kicked for Input Automation :: Counter-Strike 2 General Discussions
I don't use macros or anything like that and my keyboard doesn't have snap tap It seems to only happen when counter strafing but not always I read that changing the input latency (not polling rate) of the keyboard could help reduce the frequency and so far it has in my case Just curious if anyone has any suggestions
- Mouse DPI Polling rate - any advice? - Steam Community
Hey, until recently i have been using a really cheap Poundland mouse and have noticed I'm at quite a disadvantage in games like this and CSGO So i purchased a low cost "gaming" keyboard and mouse setup, which is a slight improvement Since then I have researched quite a bit and as far as I can tell this is whats important (please correct me if im wrong): 1 Set the windows mouse sensitive
- Whats a good DPI for a mouse? :: Hardware and Operating Systems
You can prove us right by simply setting your display to 60Hz, and then setting polling rate of your mouse to 125Hz (which is the MINIMUM setting for polling rate) and moving the mouse around before changing polling rate back to at least 500Hz, you'll see the freaking difference because 125Hz has a crap ton of latency, 8ms, compared to 1ms of
- Steam Community :: Guide :: How to Reduce Input Lag in CS2
Go to Settings → Keyboard Mouse Enable Raw Input (ON) 2 Disable Mouse Acceleration in Windows Open Control Panel → Mouse Go to Pointer Options Uncheck "Enhance pointer precision" 3 Optimal DPI and Polling Rate DPI: 400–1600 (recommended: 800) Polling Rate: 1000 Hz (lowest possible latency)
- Keyboard can cause FPS drops? :: TEKKEN 8 General Discussions
Edit: Just solved this switching dir arrows to keyboard config 1 Left Stick, before doing so remember to remove dir arrows from keyboard config 2 or you can't use them in config 1 For testing purpose just alternate right arrow and A, the speed doesn't matter, I was getting 55 fps consistent, with the new settings the problem is gone
- polling rate on keyboard :: Hardware and Operating Systems
© Valve Corporation Todos os direitos reservados Todas as marcas registradas são propriedade dos seus respectivos donos nos EUA e em outros países
|
|
|