安裝中文字典英文字典辭典工具!
安裝中文字典英文字典辭典工具!
|
- ABS pump and module!!!!!! - Dodge Cummins Diesel Forum
When replacing the abs pump or abs module on a 3rd gen cummins (2004 2wd) Does it have to be programmed and does it matter if the new rebuilt abs pump or abs module is from a 4WD dodge?
- Recommended timing | Cummins Diesel Forum
I have a 95 175hp p pump that is going on an older engine in place of a ve pump that is giving out on me The engine (including the pump) was 100% stock, and was set at 12 5 degrees timing I am thinking of setting it to about 17 degrees The 12v Cummins engine (this one is getting the p pump) is in a old chevy school bus converted to a motorhome
- Fuel pump up grade | Cummins Diesel Forum
If the lift pump was failing the engine wouldn't restart By saying the fuel heater isn't on does that mean the pre-filter strainer isn't there either? The spacer for the heater strainer keeps the lift pump at the proper distance from the block Have you checked for air leaks in the lines between the fuel tank and the lift pump?
- Wanting to swap from VE pump to P-Pump. . . - Dodge Cummins Diesel Forum
VE Injection pump from The Hungry Diesel Maxed out stock ve pump (250-260cc on average) Including THD fuel pin and gov spring of your choice!" The next step up from THD the description is as follows "The Hungry Diesel very own Competion VE pump! This pump has done up to 648hp, fuel only, and pushes up to 320cc Average cc is between 295-320cc
- VP44 Diagnostic for everyone. | Cummins Diesel Forum
If the electric lift pump doesn’t come on, or doesn’t pump fuel into the filter bowl when you click the key to the “start” and release it to the “run” position, you can bleed the system to get fuel to the VP44 and get the engine to run again, by pressurizing the fuel tank with air pressure, or diagnosing the electric lift pump
- P Pump Swap | Cummins Diesel Forum
You will have to get a benched 12mm or 13mm p pump to be able to outdo a competition ve Noteworthy that you will lose drivability with the static timing Jaeger-12 ram 3500, CCLB, 68rfe, 2" lift, 5" tbe, steed, s476, MM3 w Warp, ISSPRO factory match, ARP 625's, Hamilton 103's extreme duties, T Rex traction bars, mag hytec trans pan, build thread
- Lift Pump Upgrade Gen2 with Retrofit Tank Pump
The Fleece pump groaned a bit to fill at first and then it's much quieter than the ringing sound of the OEM pump I just loosened the VP44 nut on the return line and that's all it needed She started right up and sounded good No leaks anywhere Nice! First pic tells the final story I had lift pump PSI from 8 PSI idling to 2 PSI with a heavy foot
- Power steering pump install question. Update and fix
Working on a buddy's 2nd gen, and replaced the power steering pump because of a leak I mounted the new pump without the studs, and made sure I clocked it correctly as the pump fully mated up to the back of the vacuum pump Installed studs through vacuum pump ears and completed install The issue is, I have no pump action
|
|
|