安裝中文字典英文字典辭典工具!
安裝中文字典英文字典辭典工具!
|
- Fasteners on curved surface | Eng-Tips
Working on a sheet metal assembly where I need to put some screws through the side wall of a circular cylinder But SolidWorks refuses to properly mate the screws to the holes in the assembly Can't add any relations to get the screws properly positioned relative to the holes, and Smart
- amp readings? | Eng-Tips
here's the story, the plumbers in the building maint department say there is a clog in the 8inch pipe down the line from the discharge well when the pump runs,after about 30mins, it heats up and the amp reading are 6 4amps on each phase the nameplate on the motor is 9 5amps on a 480volt connection question, if there was a clog on the pipe wouldn't the amps be higher than 9 5amp and than
- Power Factor Correction and power saving for home use? Dirty power . . .
This IEEE article explains that PFC helps smart meters read correctly otherwise they can overcharge you for power by up to 582%
- Primary Value of Smart Dimension dimmed out | Eng-Tips
Hello, Newbe to SolidWorks 2010 I am designing a part with a slot in it The slot is supposed to be 30mm wide and I erroneously made it 40mm wide Using the Smart Dimension tool I want to change the dimension However the Dimension panel shows the Primary Value dimmed out and I cannot
- Pipeline design for pigging - general advise | Eng-Tips
A few years ago the smallest smart pig you could find was 6-inch, I hadn't heard that anyone was marketing a 2 or 3-inch smart pig these days--the industry tends to think of 2 and 3-inch pipe as disposable
- Instantiating Document Templates | Eng-Tips
I've noticed recently when instantiating document templates, sometimes it saves the files as CATProduct123 CATProduct or CATPart123 CATPart, and not save the file to the instance part name in the tree I've also noticed it somemtimes pulls a copy of the document template highest product level
- antenna delta match impedance | Eng-Tips
Anyone know where to find the equations for dimensions of a delta-match for a desired impedance? I find dimensions for 600ohm delta match everywhere A 300ohm should tap a little closer to the middle of a half-wave dipole I can't seem to find equations for this anywhere online I know that
- Part Number | Eng-Tips
Hello everyone, My company and I are struggling to establish a consistent part numbering system for our parts and assemblies We work with boilers, screw conveyors, bag filters, cyclone dust collectors, and similar equipment Currently, we’re using a system where the part name includes the
|
|
|