安裝中文字典英文字典辭典工具!
安裝中文字典英文字典辭典工具!
|
- How to enable SAI MCLK on iMX8MP? - NXP Community
What is required to output a clock e g on the `SAI2_MCLK` pin? With iMX8MM, the clock started immediately after iomux have been configured E g in barebox bootloader I see the signal aftermw 0x303301c8 0 But on iMX8MP the signal stays staticmw 0x303a00d8 32 ## power up audio block mw 0x30330
- Solved: IMX8DX SAI2 MASTER MODE - NXP Community
But SAI2 SAI3 cannot able to generate while it is configured in master mode Is it possible to use SAI2 as a master and generate bit frame sync clock for other slave device like FM module? The data sheet shows SAI2 is receive only and contains pinmux as ADMA_SAI2_RXC, ADMA_SAI2_RXD and ADMA_SAI2_RXFS
- Audio sai2 mclk - NXP Community
mx6ul_pad_jtag_tms__sai2_mclk 0x17088 MX6UL_PAD_SNVS_TAMPER4__GPIO5_IO04 0x17059 after system booting is done, you can play a music file, then measure the clock on the JTAG_TMS Pin to check if the clock value is what you want
- Solved: Re: sai2，如何直接输出I2S信号 - NXP Community
Hi，weidong 请问linux,bt-sco这个程序应该参考哪个程序编写呢？
- iMxRT SAI in synchronous mode - NXP Community
Hello, I am evaluating the SAI capabilities of the iMxRT1050, and I have a problem running SAI1 and SAI2 in synchronous Master mode: I want to use the SAI1 Tx Clocks (TX_BCLK and TX_WCLK) as reference clocks for all other data lines SAI1 and SAI2 To achieve that I configured the 2 SAIs the same w
- iMX8M SAI Master Clock Skipping - NXP Community
Hello, I wrote a codec driver and modified the "fsl-asoc-card c" driver to work with my system, which went surprisingly well My system consists of the following: iMX8M SAI2 connected to a TLV320ADC3100 with SAI I2S interface plus I2C3 for register read write The expectation is that the iMX8M pro
- [IMX8M Nano] SAI synchronous mode and TDM setting.
But I already understand that only SAI2 and SAI3 can use multi synchronous mode My questions are following 1) Can multi synchronous mode and TDM be used at the same time? 2) Bit31 of SAI TRC2 and RRC2 register is assigned to enable disable in multi-sync mode, but it can use only SAI2 and SAI3 can be used How about bit30 of TRC2 and RRC2?
- Solved: sai2，如何直接输出I2S信号 - NXP Community
Solved: 请问imx6ull如何直接输出I2S信号，连接蓝牙模块。 Hi, 在我们的i MX8MP dts中支持了bt autio,你可以参考这些配置。
|
|
|