安裝中文字典英文字典辭典工具!
安裝中文字典英文字典辭典工具!
|
- 302. 1R-04 Guide for Concrete Floor and Slab Construction
9 8—Protection of slab during construction 9 9—Temperature drawdown in cold storage and freezer rooms 9 10—Joint filling and sealing Chapter 10—Quality control checklist, p 302 1R-61 10 1—Introduction 10 2—Partial list of important items to be observed Chapter 11—Causes of floor and slab surface imperfections, p 302 1R-62
- ACI 360R-10 Guide to Design of Slabs-on-Ground
3 2—Slab types 3 3—General comparison of slab types 3 4—Design and construction variables 3 5—Conclusion Chapter 4—Soil support systems for slabs-on-ground, p 360R-8 4 1—Introduction 4 2—Geotechnical engineering reports 4 3—Subgrade classification 4 4—Modulus of subgrade reaction 4 5—Design of slab-support system 4 6—Site
- SP-17M(14): The Reinforced Concrete Design Handbook
An ACI Handbook The Reinforced Concrete Design Handbook A Companion to ACI 318M-14 SP-17M(14)
- 421. 1R-20: Guide for Shear Reinforcement for Slabs
D 1—Interior column-slab connection, p 21 D 2—Edge column-slab connection, p 23 D 3—Corner column-slab connection, p 24 D 4—Prestressed slab-column connection, p 26 CHAPTER 1—INTRODUCTION AND SCOPE 1 1—Introduction In flat-plate floors, slab-column connections are subjected to high shear stresses produced by the transfer of the
- Consolidation of concrete—required or not?
We always require concrete slabs to be vibrated, regardless if they are cast on ground, temporary formwork, or metal deck I know that ACI 301 provides provisions for vibrating normal-weight concrete and lightweight concrete, but does it have a section that explicitly states that a concrete slab must be vibrated?
- Concrete Placements Exposed to Rain
Keywords: surface, slab, finishing, rainwater DOI: Date: 8 1 2019 Abstract: Concrete can be exposed to rain at various stages of placements Being prepared for a rain event allows potential risk to be managed effectively The article discusses the harmful properties of rainstorms and potential types of damage that can occur
- Difference between a contraction joint, isolation joint, expansion . . .
A A contraction joint is formed, sawed, or tooled groove in a concrete structure to create a weakened plane to regulate the location of cracking resulting from
- ACI PRC-421. 3-15 Guide to Design of Reinforced Two-Way Slab Systems
6 1—Minimum slab thickness 6 2—Deflection analysis 6 3—Crack control in reinforced two-way action structural slabs and plates CHAPTER 7—DESIGN OF SLAB-COLUMN FRAMES UNDER LATERAL FORCES 7 1—General 7 2—Analysis of slab-column frames under lateral forces 7 3—Arrangement of reinforcement in slabs for intermediate moment frames
|
|
|