安裝中文字典英文字典辭典工具!
安裝中文字典英文字典辭典工具!
|
- Difference between SVI and subinterface - Network Engineering Stack . . .
Whereas SVI(switch virtual interfàce) are configured in layer3 switches or multilayered switch the switch which can operates on both layer2 and layer3 SVI configuration in layer3 switch will ensure communication between different Vlans or different subnets Sub interfàce configuration in router It is L3 interfàce for particular subnet
- vlan - Can anyone please explain L3 SVI configuration ,What is SVI and . . .
A layer-2 switch can use a layer-3 SVI as its management interface, and it would also need a default gateway in the VLAN to allow the management interface to be reached from other networks through the router at the default gateway address For a layer-3 switch, a layer-3 SVI is a gateway for the VLAN
- Switch virtual interface - Network Engineering Stack Exchange
"Single SVI can be mapped to a VLAN " That is odd phrasing and an awkward way to look at it An SVI is the virtual interface created on a particular VLAN Notice the way the SVI is created: interface Vlan<vlan number> The SVI is an interface for exactly one VLAN, which is the VLAN in the interface name –
- Some extra clarification regarding VLANs and SVI
Just configuration SVI in switch deployed in core layer and configure trunk ports between distribution switch or access switch to ensure passing all vlan between core switch and access - switch And further connect computers or servers to access -switches by passing specific vlan on access -port as per requirement
- Multiple IP Addresses on VLAN Interface (SVI)
If the SVI must change from 192 168 1 1 24 to 192 168 1 1 25 and the host's IP address cannot change, then the host will lose connectivity unless proxy-arp is configured on the SVI Assigning a temporary, secondary IP address to the SVI in the 192 168 1 0 25 subnet violates the requirements because at some point the primary IP will have to be
- Understanding traffic flow on SVIs [closed] - Network Engineering Stack . . .
If an input policy is configured on an SVI, only traffic which is actually using the SVI as next hop will be affected If traffic needs to be routed from an SVI to another SVI, this doesn't mean that the second SVI is another ingress, it is in fact an egress interface, there is no double input on a route lookup or L2 lookup
- Whats `irb` meaning? and whats the difference between it and `vlan`?
Enhanced Layer-2 Switching (ELS) Juniper has a couple of different product lines (routers, switches, firewalls) that theoretically run the same operating system (Junos)
- How do you ping between VLANs? - Network Engineering Stack Exchange
If your switch has L3 ability, you can issue the ip routing on the global config and then use the ping Also the L3 communication between VLAN interfaces (as known as SVI on Cisco literature) starts to work This test can be done either on the switch itself or by the hosts which are connected to their respective VLANs
|
|
|