安裝中文字典英文字典辭典工具!
安裝中文字典英文字典辭典工具!
|
- What is a synchro and what are its types - AutomationForum
Principle operation of synchro Synchro is a form of a rotating transformer that resembles a small AC motor and they are widely used as an element of measuring and control systems involving rotatable shafts The primary coil is wound on the rotor and couples magnetically to the secondary coils on the stator and the connections to the external terminals are through slip rings Synchros mostly
- Whats the differences between a Resolver and a Synchro?
The biggest difference between synchros and resolvers is their construction difference They both have a single-winding rotor But the stator of a synchro has three windings oriented 120 degree apart and electrically connected in a Y-connection The stator of a resolver differs from a synchro in that its stator has two windings oriented in 90
- how to get the angle from a 3 phases synchro signal
I'm trying to understand how to get the value of the shaft position from a synchro I've looking in mutiple documentation but none explains how to calcuate the angle value from : I'm looking
- motor - Old 7-wire Autosyn resolver: how to use it? - Electrical . . .
I have just bought online what I thought was a synchro as described in this page, but I am trying to get my head around how to use it since it does not correspond to any of the types I currently know: it has 7 wires
- Control synchro system - Electrical Engineering Stack Exchange
I have some questions regarding this system that is supposed to take in an input signal and move the load according to this signal The current load position is feedback to the CT, which compares the
- LTspice IR2104 SynchroBuck Simulation problem
I am trying to simulate a basic synchronous buck converter with LTspice but transient analysis won't go above 0% when I connect the NMOS part Without NMOS part which is below HO and LO just do the
- Synchro with 1 phase grounded - Electrical Engineering Stack Exchange
A synchro is a transformer, there's no internal galvanic connection between the S and the R terminals, so neglecting stray capacitance, you can ground any one of the S terminals and any of one of the R terminals without altering the performance The usual way to use a synchro is to generate a three-phase waveform 120° between phases, use them to drive the three S terminals, and detect the
- Read Parallel CMOS ADC using (STM32)DCMI interface
0 I have an external ADC with 3 outputs, 2 bit (I0,I1) and 1 clock (clk_out) I am trying to read those pins at the falling clock edge using DCMI in NUCLEO-H743ZI2 board, I wrote a code using HAL where I set the DCMI in Slave 8 bits embedded synchro modes
|
|
|