安裝中文字典英文字典辭典工具!
安裝中文字典英文字典辭典工具!
|
- 1969 L78 4 Speed - Team Chevelle
Selling my original engine, KK 4 10 rear end Garnet Red bench seat 4 speed car The M21 is a freshly rebuilt tranny Jerry McNeish certified Full working A I R smog system The engine has been rebuilt, as the rear end I have the notes from the engine rebuilder The car has been restored, but
- How much fluid for a TH-400 - Team Chevelle
Here is an easy one My tranny gasket was about gone so I replaced it I dropped the pan, changed the filter and gasket and then replaced the pan I put four qaurts Dextron Mercron III tranny fluid into it Started motor, let it get hot, shifted through all gears and checked the fluid level
- How do I determine correct fluid level in a TH-350. . . . .
In addressing some problems in a recently acquired 87 El Camino, I pulled the driven gear bullet to replace leaking seals At least half a quart of tranny fluid poured out If my memory serves me correctly, when I have pulled this speedometer gear housing in the past from other 350s, I only
- Pulling engine, with or without transmission attached
This allows me to lower the car back down after the engine tranny is out most of the way and gives needed clearance over the front of the car It really helps to have a couple of buddies to help
- Pilot bushing and Muncie Tranny - Team Chevelle
The tranny is marked as: on case - GM patent # 3088336 then 7-1, then P R07 On slider shift cover plate - 3884685, on the spline input shaft housing - GM14 and 38 (or 9)15020 The tranny case to the end of the input shaft measure 6-9 16" The pilot section in the bushing is 1 750" - 1 800" long, The 10 spline end is 2 350"
- Transmission for 454 Big Block - Team Chevelle
Hey all, I've been looking on the internet for a good transmission that will be reliable enough to handle a 454 engine with about 500-600HP I've hear 400 turbo transmission and 700r transmission Looking to buy a new one rather then a rebuilt one It would be used as a daily driver and cruiser
- Cant get tranny splines to line up with clutch disc splines. . .
Well after putting in the new clutch and bellhousing I tried to get the transmission in with absolutely no luck I thought that things weren't aligned correctly and the input shaft was hitting the pilot bushing Well I take the bellhousing off and re-align the clutch disc with a clutch
- What size tranny cooler to use - Team Chevelle
What size tranny cooler to use ? Jump to Latest 7 3K views 10 replies 9 participants last post by Bbbad1 Jan 24, 2019 B
|
|
|