安裝中文字典英文字典辭典工具!
安裝中文字典英文字典辭典工具!
|
- terminology - What part of a cabinet is the carcass? - Woodworking . . .
What is a carcass (or carcase)? Does the term have general usages in woodworking outside of cabinetry? A cabinet, for example, consider the American style one on the right: If I remove the doors,
- carcass - How to build wardrobe with top shelf? Actual shelf, or two . . .
The traditional, and least visually disruptive to the exterior appearance of your wardrobe, would be to mount the shelf inside a full height carcass If you do this, though, you want the construction method to allow you to put the shelf in after the carcass is fully constructed and stabilized
- Correctly spacing drawer runners (with soft close mechanism)
My carcass is 710mm tall with 18mm base and spacer, so the height for drawer runners is 710 - (2 x 18) = 674mm I have bought some of the Hafele metal drawer system drawers
- joinery - What are some best practices and techniques for building . . .
cleats on the inside corners, fastened with glue and screws nails In all cases, you should usually also glue the joints for improved strength; if using a nailgun the nails only serve to hold the carcass (cabinet box) together while the glue dries You can hide your fasteners by strategically positioning them
- Highest scored carcass questions - Woodworking Stack Exchange
I am wanting to build a wardrobe with a shelf above the rail, but I am not sure how will be the appropriate way to go about it from the actual carcass construction to how to make the shelf itself I
- Understanding how to fit euro style half overlay hinges
Carcass is 3 4" and I would like to get roughly half of it covered (9 or 10mm) I am reading about half-overlay hinges but it seems that they have a specific application (namely side-to-side cabinets with single panel)
- Flush fitting to an uneven surface - Woodworking Stack Exchange
@Programmer66 diagrams added The front of the cabinet "box" is designed to be flush with the wall, with the doors and drawer faces closing against the wall But as the wall is not flat and the cabinet is flat, there are places where it protrudes out I'm thinking to make it protrude out everywhere to make this less obvious by adding a thin piece of timber for the doors drawers to close up
- Newest carcass Questions - Woodworking Stack Exchange
I am wanting to build a wardrobe with a shelf above the rail, but I am not sure how will be the appropriate way to go about it from the actual carcass construction to how to make the shelf itself
|
|
|