Can the management VLAN on a USW Flex Mini be tagged? : r Ubiquiti - Reddit So - I am aware the USW-Flex-Mini has limited VLAN support - i e that it can have untagged (access mode) switch ports but not tagged (trunk) vlan ports But -- does this limitation apply to the "switch brain" itself (i e the part inside the switch that is technically not a physical port, but it connects to the controller)
Switch Port VLAN Assignment (Trunk Access Ports) Use the Tagged VLAN Management setting to configure any VLAN restrictions Allow All (Trunk Port): By default, UniFi switch ports allow traffic from all VLANs created in UniFi Block All (Access Port): This option only permits traffic to pass on the Native (Untagged) VLAN
Is there any reason to have a VLAN untagged on port that is tagged with . . . For inter-switch trunks, tag all That helps avoid problems caused by mismatched configurations (different VLANs untagged at each end and or mismatched PVID) The most common case for an untagged VLAN would be a VoIP system, where there's a tagged voice VLAN and an untagged data VLAN
Port Configuration: Native VLAN Network and Tagged VLAN Management I’m trying to figure out what the fields Native VLAN Network and Tagged VLAN Management mean in a Unifi controller (USG-3) under port configuration I’m not clear on what untagged traffic is When is traffic tagged and what device tags it?
6100 Management on Tagged VLAN | Wired Intelligent Edge For the benefit of anyone else with a similar issue, the trunk from the 6100 (CX) is to a 6400R (ArubaOS) which has VLAN 1001 TAGGED B24 on the trunk port B24 to the 6100 Original Message Sent: Sep 29, 2022 02:14 PM
Solved: How to Tag Vlan on trunk ports - Cisco Community The vlan id is included into the header, now if you want to specify the VLAN passing through over a trunk so you can use the following line: interface gx x x switchport mode trunk
Management VLAN. . . tagged or untagged? : r networking - Reddit Some devices require I tagged clans for management though (such as ubiquiti access points) so on the trunk to the ap only, untagged The untagged VLAN aka native VLAN in 802 1Q shouldn’t be used for anything