安裝中文字典英文字典辭典工具!
安裝中文字典英文字典辭典工具!
|
- IP Inspects -- Why do we need them? - Cisco Learning Network
ip inspect name FWOUT udp ip inspect name FWOUT icmp ip inspect name FWOUT ftp This will tell our IOS firewall to properly inspect and handle ftp traffic In other words, this adds the some specific protocol intelligence that is required to handle ftp What about other protocols, like SMTP? Shouldn’t that work since there are no secondary
- IPSec Traffic Through Cisco ASA: Understanding NAT and Inspection Scenarios
[inspect UDP 500] ASA tracks ISAKMP negotiation over UDP 500 and automatically permits associated ESP or UDP 4500 traffic Properly allowing IPSec traffic through Cisco ASA depends on whether NAT is applied and whether IPSec inspection is enabled
- Zone-Based Policy Firewalls 5 step process - Cisco Learning Network
My example PMAP action will be to inspect the class map Here you can also define the policy action to pass or drop traffic Step 5 you will create a service policy by naming it and identifying the flow in which traffic is going and identifying the zone membership (zone-membership) and use the names of the zones we created
- DNS Inspection problem - Cisco Learning Network
Hi Team, I have been having problems with DNS inspection and I can't seem to make it work DNS resolutions to public DNS doesnt work Any thoughts? Here is the packet trace: ASA# packet-tracer input INT-WIRELESS-GUEST udp 192 168 254 172 65535 4 2 2 2 53 Phase: 1 Type: FLOW-LOOKUP Subtype: Result: ALLOW Config: Additional Information: Found no matching flow, creating a new flow Phase: 2 Type
- Zone Based Firewall Part 1 - Cisco Learning Network
Inspect Allows for stateful inspection of traffic flowing from source to destination zone, and automatically permits returning traffic flows even for complex protocols, such as H 323
- Inspection on cisco router ISR4431
Hi Loc, Take a look at this example It shows how stateful inspection is configured in IOS XE devices Security Configuration Guide: Zone-Based Policy Firewall, Cisco IOS XE Release 3S - Firewall Stateful Inspection of ICM… Example: Configuring Firewall Stateful Inspection of ICMP Device# configure terminal Device (config)# access-list 102 permit icmp 192 168 0 1 255 255 255 0 192 168 2 22
- Class Map [match default-inspection-traffic]
Sure you can do that By default, class-map inspection_default is assigned to global_policy policy-map and to view the protocols inspected by default on ASA use following command
- ASA Default Inspection - Cisco Learning Network
Hi Atul, Inspection refers to the ASA's ability to look inside the configured protocols and perform certain actions based on the 'controlplane' traffic found in the traffic flow The ASA has an understanding of the protocols it can inspect Some protocols, such as FTP, can dynamically open additional ports for data transfer The inspection is not required as such, but some protocols won't work
|
|
|