安裝中文字典英文字典辭典工具!
安裝中文字典英文字典辭典工具!
|
- linux - using Iperf3 to test upload and download - Server Fault
iperf3 per default just tests the upload speed But you can perform a simultaneous upload and download by using --bidir on the client side: iperf3 -c 192 168 1 xxx --bidir On some newer Linux distributions, the -d flag is used instead: iperf3 -c 192 168 1 xxx -d This way you can get both results in a single test
- iPerf3 for beginners - Routers - GL. iNet
Connect iperf3 to the server via command line: \iperf3 exe -c 192 168 177 1 The IP naturally corresponds to the IP of the router Read the results Both programs can be interchanged - i e you can start the server mode (-s) on the client and the client mode (-c [IP of the client]) on the router And vice versa iperf3 without any command will
- linux - iperf connect failed: Connection refused - Server Fault
This is what happened to me The windows version had the newest one (3 1 3) while for arch installing iperf gave me an old 2 0 5 Installing iperf3 on arch gave me the newest version, after which all went well –
- iperf3 error - unable to create a new stream: permission denied
I am new to using iperf but others in my company use it but today it is acting strangely From the server: iperf3 -s which results in cmd showing: Server listening on 5201 From the client: iperf
- iperf - How to measure network throughput with IPerf3 and multiple . . .
I have a particular device which acts as a "strange" TLS proxy and I want to measure the throughput of it with IPerf3 The device under test is "Peter" It has an API to trigger connection to two TLS servers It will proxy their payload from one channel to another I can run on "Alice" IPerf and before it socat as a TLS proxy
- Getting an iperf connect failed: connection refused error on ubuntu . . .
Even though my servers are running, the clients are not able to connect to them I also tried this with iperf3 and in this case, one computer could connect to the 2 other computers, one computer could connect to only one other computer, and the third couldn't connect to either one of the computer
- using random ports with iperf iperf3 - Server Fault
iPerf3 is a tool for active measurements of the maximum achievable bandwidth on IP networks It supports tuning of various parameters related to timing, buffers and protocols (TCP, UDP, SCTP with IPv4 and IPv6) My question is how to use random port with a specific range (5300-5400) while using Iperf iperf3 -c remotehost
- How to set the UDP Packet Size with iperf3? - Server Fault
There isn't a way to do it directly in iperf3 However, you can adjust down the MTU size set on your network interface, and iperf will respect that So long as you're looking to set your packet-sizes smaller than the actual network MTU, that is
|
|
|